Claim Missing Document
Check
Articles

Found 3 Documents
Search

The Self Exitated Induction Generator with Observation Magnetizing Characteristic in The Air Gap Ridwan Gunawan; Feri Yusivar; Budiyanto Budiyanto
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 5, No 3: 2015
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (419.323 KB) | DOI: 10.11591/ijpeds.v5.i3.pp355-365

Abstract

This paper discusses the Self Exitated induction Generator (SEIG) by approaching the induction machine, physically and mathematically which then transformed from three-phase frame abc to-axis frame, direct axis and quadratur-axis. Based on the reactive power demand of induction machine, capacitor mounted on the stator of the induction machine then do the physical and mathematical approach of the system to obtain a state space model. Underknown relationships, magnetization reactance and magnetizing current is not linear, so do mathematical approach to the magnetization reactance equation used in the calculation. Obtained state space model and the magnetic reactance equation is simulated by Runge kutta method of fourth order. The equation of reactance, is simulated by first using the polynomial equation and second using the exponent equation. The load voltage at d axis and q axis using the polynomial laggs 640µs to the exponent equation. The polynomial voltage magnetitude is less than 0.6068 volt from the exponent voltage magnitude
Critical Condition of Sensorless Induction Generator Using Flux Weakening in Wind Turbine Application Nanda Avianto Wicaksono; Abdul Halim; Aries Subiantoro; Feri Yusivar
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 7, No 1: March 2016
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijpeds.v7.i1.pp202-216

Abstract

This paper was intended to examine thoroughly a critical condition of the sensorless induction generator using flux weakening in wind turbine application. The critical condition would happen when the rotor speed reached the critical rotor speed reference. The critical rotor speed reference was the highest of the rotor speed reference that still caused the stable response. It was obtained by increasing the rotor speed reference until the system response became unstable. In the low speed range of wind showed that there was no unstable condition whatever a rotor speed reference was set. On the other hand, there was a critical rotor speed reference in the medium and high speed range of wind. The unstable condition was caused by the induction generator that received a power higher than its capacity, so its rotor speed couldn't be maintained at reference value. The first solution was suggested that the stable condition would be made by setting the rotor speed reference at the minimum critical reference. The second solution was suggested that the controlling rotor speed in triangle area between the critical condition and the operation that used the minimum critical reference for the rotor speed reference. In the triangle area, the rotor speed was controlled by setting the tip speed ratio.
Control of DFIG Stator Voltage on Autonomous Micro Hydro Power Plant Feri Yusivar; Nanda Avianto Wicaksono; Aries Subiantoro; Ridwan Gunawan
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 7, No 2: June 2016
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (346.049 KB) | DOI: 10.11591/ijpeds.v7.i2.pp498-508

Abstract

An autonomous micro hydro power plant was proposed to utilize the small hydro power potency as a run-of-river. It consisted of a PMSG, a DFIG, and a converter and should be operated in the off-grid configuration. In a previous research, the DFIG stator voltages couldn’t be controlled. In this paper, the novel control algorithm that is able to maintain the DFIG stator voltages of the autonomous micro hydro power plant in the off-grid configuration is proposed. The control algorithm was proposed to use the actual DFIG stator voltages and currents as feedback signals. The controller was tested by varying three input signals, i.e. the DC-link voltage, the DFIG stator voltage reference, and the external stator load which simulated the off-grid configuration. The result of the simulation showed that the DFIG stator voltages could be controlled and were always in accordance with the reference.