Claim Missing Document
Check
Articles

Found 3 Documents
Search

Power flow management of triple active bridge for fuel cell applications Nageswara Rao Kudithi; Sakda Somkun
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 10, No 2: June 2019
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (555.887 KB) | DOI: 10.11591/ijpeds.v10.i2.pp672-681

Abstract

The power conditioning circuits which are used in fuel cell systems should carefully be designed to prolong the life span of the system, for the reason of the dynamic nature, such that the unexpected and extreme changes in load decreases the life of the fuel cells. This paper presents the triple active bridge (TAB) and it’s average small signal modelling, which is used for design of the system controllers for stable operation. The extended symmetrical optimum method is used for realized the proportional integral (PI) controller, to control the output/Load voltage and power flow in the fuel cell/Source with a guaranteed minimum phase margin for the system with a variable process gain in addition to other accepted desired performances. This method ensures the maximum phase margin at a minimum required value at the desired gain crossover frequency with a compromise between system’s peak overshoot, rise time and settling time. This model and this approach helps in designing TAB suitable for healthy and uninterrupted fuel cell power generation systems as a part of a renewable /clean energy system. MATLAB/Simulink is used to simulate the proposed controllers with TAB.
A study of a single phase grid connected pv inverter performance under a weak grid conditions and distorted grid voltage for Cambodia Sovanna Phoeurn; Sakda Somkun
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 12, No 2: June 2021
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijpeds.v12.i2.pp1055-1068

Abstract

A single-phase grid-connected PV inverter performance under a weak grid is a model designed to penetrate PV energy with a weak grid. Usually, this model gets complex and unstable in power system control such as THD growth, harmonic effects, voltage surges, inverter performance. Experimental results would present the impacts on the system which would lead to instability in the grid system. This study was based on inverter performance control, a weak grid control, the grid distortion examination, and harmonic effects. To optimize this grid system, hence, the proposed methods of oscilloscope and power meter were proportionally used to control the grid impacts and stabilities. The results showed that current THD in distorted grid voltage system surged to 8.88%. VPCC growth was 238.11V, equivalent to 8.23% in a weak grid (XL and R). Such a huge increase could prevent the grid system from transferring power for later operation. During the experiment, the inverter, S power and Q power performances stood for good operating processes without impacts on the grid performance. This method  should be applied with a weak grid system because it provided information about grid stability control.
Single Phase Power Generation System from Fuel Cell Nageswara Rao Kudithi; Sakda Somkun
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 9, No 4: December 2018
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijpeds.v9.i4.pp1676-1684

Abstract

Power conditioning circuits are required for the fuel cell systems due to its nature in energetic state. This paper proposed the small signal average modelling of a duel active bridge (DAB) DC-DC converter with LC filter, to generate the single phase AC power by using the H1000 fuel cell system. The controller is designed for the stable operation of the system. Implemented the controller, which gives the constant output voltage to DC-bus from the DAB DC-DC converter, this DC-bus voltage fed to the inverter, which inverts the DC-bus voltage to single Phase AC power with the LC-filter. The proposed system simulated in the MATLAB/Simulink.