Muhammad Yusof Mohd Noor
Universiti Teknologi Malaysia

Published : 3 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 3 Documents
Search

Discrete liquid level fiber sensor Muhammad Yusof Mohd Noor; Ahmad Sharmi Abdullah; Asrul Izam Azmi; Mohd Haniff Ibrahim; Mohd Rashidi Salim; Norazan Kassim
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 17, No 4: August 2019
Publisher : Universitas Ahmad Dahlan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.12928/telkomnika.v17i4.12769

Abstract

A novel simple fiber sensor to sense liquid level is presented. The operation principle is based on the relative Fresnel reflective intensity. The sensor consists of a fiber splitter with the configuration of one input to multiple fiber outputs, i.e. 1×4, 1×8 and 1×12 arrangements that act as a discrete liquid level. A broadband source (BBS) is used as the light source supply. The total reflected power intensity is measured using a power meter. Experimental results show that the power intensity decreases as the level of liquid is increased. The sensor has a simple configuration, low cost, and it can be customized for a wide height measurement range spanning from a few centimeters up to a hundred meters.
A low-cost fiber based displacement sensor for industrial applications Siti Mahfuza Saimon; Nor Hafizah Ngajikin; Muhammad Shafiq Omar; Mohd Haniff Ibrahim; Muhammad Yusof Mohd Noor; Ahmad Sharmi Abdullah; Mohd Rashidi Salim
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 17, No 2: April 2019
Publisher : Universitas Ahmad Dahlan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.12928/telkomnika.v17i2.9754

Abstract

In this paper, a low-cost fiber optic displacement sensor (FODS) using a bundle of plastic optical fiber (POF) as a probe is developed and presented. The sensor consists of a high power light emitting diode (LED) as light source, a probe with multiple receiving plastic optical fiber and a photodiode detector. The sensor is characterized at millimeter distance and the sensor output is analyzed from 0 mm to 13 mm displacement. The sensitivity of the sensor is found to be 5.38 mV/mm over 2.6 mm sensing range. The sensor is very useful for close distance target since it is highly sensitive at the front slope. The low development cost, high degree of sensitivity and simplicity of the design make it suitable for wide range of industrial applications.
Graphene-polyvinyl alcohol polymer based saturable absorption at 2000 nm region Nabihah Hussin; Asrul Izam Azmi; Mohd Rashidi Salim; Muhammad Yusof Mohd Noor; Ahmad Sharmi Abdullah; Michael David; Fauzan Ahmad; Mohd Haniff Ibrahim
Indonesian Journal of Electrical Engineering and Computer Science Vol 27, No 2: August 2022
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijeecs.v27.i2.pp701-708

Abstract

A graphene-polyvinyl alcohol (PVA) composite saturable absorption is demonstrated at 2000 nm region. Graphene suspension is produced using low-cost electrochemical exfoliation process. The suspension is mixed with PVA host polymer in 1:1 ratio and left evaporated at room temperature which finally produced graphene-PVA thin film. Thulium doped fiber (TDF) gain medium has been shown to produce a stable Q-switched pulse with a highest repetition rate of 54 kHz, a short pulse duration of 2.89 µs, a maximum peak power of 16 mW, and an estimated maximum pulse energy of 49 nJ. Apparently, at 2000 nm region, superior performances of graphene-PVA composite have been recorded which was largely contributed by meticulous composite preparation and homogenous mixture with PVA host.