Article Per Year (5 Year)
p-Index From 2019 - 2024
0
P-Index
This Author published in this journals
All Journal Aceh International Journal of Science and Technology
Muhammad Abdul Wahid
Unknown Affiliation
Agriculture, Biological Sciences & Forestry Chemical Engineering, Chemistry & Bioengineering Control & Systems Engineering Decision Sciences, Operations Research & Management Earth & Planetary Sciences

Published : 1 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search

 1 
Optimization of Multiple Response Using Taguchi-WPCA In ST 60 Tool Steel Turning Process With Minimum Quantity Cooling Lubrication (MQCL) Method Dian Ridlo Pamuji; Muhammad Abdul Wahid; Abdul Rohman; Achmad As’ad Sonief; Moch Agus Choiron
Aceh International Journal of Science and Technology Vol 7, No 1 (2018): April 2018
Publisher : Graduate Program of Syiah Kuala University

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (678.51 KB) | DOI: 10.13170/aijst.7.1.8708

Abstract

A research was conducted for the optimization of the turning process st 60 tool steel with multiple performance characteristics based on the orthogonal array with Taguchi-WPCA method. Minimum Quantity Cooling Lubrication (MQCL) metode was applied as a coolant. The experimental studies were conducted under varying the cutting speed, feeding, depth of cut and type of coolant. The optimized multiple performance characteristics were surface roughness, and material removal rate. An orthogonal array, signal-to-noise ratio, grey relational analysis, weighted pricipal component analysis and analysis of variance were employed to study the multiple performance characteristics. Experimental results show that cutting speed gives the highest contribution for minimize of surface roughness and maximize of material removal rate, followed by feeding speed, type of coolant and depth of cut. The minimum of surface roughness and maximize of material removal rat could be obtained by using the values of cutting speed, feeding speed,  depth of cut and type of coolant of 172.95 m/minute, 0.053 mm/rev, 0.25 mm, and vegetable oil as a coolant respectively.
Co-Authors Achmad As’ad Sonief Anak Agung Istri Sri Wiadnyani Dian Ridlo Pamuji Moch Agus Choiron SATRIYAS ILYAS