Article Per Year (5 Year)
p-Index From 2019 - 2024
0.23
P-Index
This Author published in this journals
All Journal Jurnal Teknik Mesin
Samuel Trinata
Unknown Affiliation
Aerospace Engineering Automotive Engineering Control & Systems Engineering Energy Engineering Industrial & Manufacturing Engineering Materials Science & Nanotechnology Mechanical Engineering

Published : 1 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search

 1 
Simulasi Perubahan Back Rake Angle Polycrystalline Diamond Carbide Drill Bit untuk Meminimalkan Keausan Pahat Oegik Soegihardjo; Samuel Trinata
Jurnal Teknik Mesin Vol. 17 No. 2 (2020): OCTOBER 2020
Publisher : Institute of Research and Community Outreach - Petra Christian University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.9744/jtm.17.2.34-37

Abstract

The drilling process of an oil well uses a drill bit to drill a hole to drain crude oil from the bowels of the earth to the ground. Tool wear occurs in every cutting or drilling process that uses tool bits. A drill bit is the general term for the tool blade used in the drilling process. Two types of tool bits that are commonly used are roller cone and Polycrystalline Diamond Carbide drill bit or PDC. The case being study is the wear out of the PDC drill bit, that causing unplanned bit trip. This research was conducted as an effort to reduce the wear that occurs on the PDC drill bit. The aim of the research is to simulate the changes of the back rake angle, so that the impact of the back rake angle's changes on the wear of the drill bit could be investigated. The results of the simulations were compared with the tool wear data that occurred at one of the oil drilling locations.  
Co-Authors Oegik Soegihardjo