Claim Missing Document
Check
Articles

Found 2 Documents
Search
Journal : Jurnal Taguchi : Jurnal Ilmiah Teknik dan Manajemen Industri

ANALISIS PENGENDALIAN KUALITAS CAT GUNA MENGURANGI TINGKAT KECACATAN DI PT. PABRIK CAT TUNGGAL DJAJA INDAH Muchamad Prayogo Utomo; Asmungi Asmungi
Jurnal Taguchi : Jurnal Ilmiah Teknik dan Manajemen Industri Vol. 3 No. 1 (2023): Jurnal Taguchi : Jurnal Ilmiah Keilmuan Teknik dan Manajemen Industri
Publisher : LPPM Universitas Bina Bangsa

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.46306/tgc.v3i1.113

Abstract

The company implements a system to monitor the quality of production results in order to obtain product quality standards that are able to challenge business competition locally and outside the region. The company's standardized product defect target is a maximum of 5% of the total production target in 1 month. When the production defect value reaches a defective quality value above 5%, it will tighten the production target and increase the production volume to obtain the desired amount. To overcome this problem, it is necessary to analyze using the Six Sigma Quality Control Method. From this study, the p control map was obtained, it can be seen that the proportion of defects is within the control limits, only in the proportion of December 2022 production control which is above the normal limit of 0.0578 from 0.0571. The most dominant type of defect is paint spots due to dust with 26% of the defect value because it has the highest percentage value with the control chart calculation which is still at the value of the proportion of defects under the control limit. The cause of the high defect rate is due to human negligence, material selection, method use, and machine maintenance
MODIFIKASI SISTEM TRANSMISI MESIN ELASTIS UNTUK MENINGKATKAN KAPASITAS PRODUKSI Asmungi Asmungi; Naradzar Wahyu Saputro
Jurnal Taguchi : Jurnal Ilmiah Teknik dan Manajemen Industri Vol. 3 No. 1 (2023): Jurnal Taguchi : Jurnal Ilmiah Keilmuan Teknik dan Manajemen Industri
Publisher : LPPM Universitas Bina Bangsa

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.46306/tgc.v3i1.117

Abstract

Fulfilling production demand is a must for any manufacturing industry anywhere, in this case the company wants to increase the production capacity of elastic machine A, where during production the target has never been met, this is due to limited machine capacity, with a percentage of 71.6% in meeting production targets and an overall equipment effectiveness (OEE) value or machine effectiveness of 71.2%. To increase this capacity is influenced by the spinning speed on the machine, the faster the rotation, the faster the production, to speed up the rotation, it is necessary to modify the transmission system, changing the pulley in the transmission system can affect the speed, the pulley size is changed from 110mm to 120mm which causes the spinning speed to increase so that the machine capacity increases, the percentage of production results after modification is 96.9% and increases the percentage of OEE value to 95.16%.