p-Index From 2018 - 2023
0.444
P-Index
This Author published in this journals
All Journal Jurnal ELTEK
Claim Missing Document
Check
Articles

Found 2 Documents
Search

Pengaruh Tegangan Kerja Terhadap Spektrum Frekuensi Gelombang Arus Bocor Pada Isolator Keramik Awan Setiawan; Imron Ridzki; Priya Surya
JURNAL ELTEK Vol 18 No 2 (2020): ELTEK Vol 18 No 2
Publisher : Politeknik Negeri Malang

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (926.828 KB) | DOI: 10.33795/eltek.v18i2.255

Abstract

Penyaluran energi listrik pada jaringan PT PLN PERSERO khususnya pada jaringan distribusi sering mengalami kegagalan yang disebabkan arus bocor pada isolator keramik. Intensitas kerusakan disebabkab oleh polutan debu yang menempel pada permukaan isolator, ditambah pula dengan kelembaban udara yang ada di daerah tropis seperti Indonesia. Hal ini secara kumulatif, menyebabkan flashover pada permukaan isolator dan menyebabkan kegagalan penyaluran energy listrik pada jaringan. Pengaplikasian Silicon Rubber sebagai bahan pelapis isolator dapat mengurangi polutan debu yang menempel pada permukaan, hasil penelitian menunjukkan bahwa parameter tegangan akan berpengaruh juga pada besarnya arus bocor yang mengalir pada permukaan isolator. Semakin tinggi tegangan kerja akan memperbesar nilai RMS arus bocor yang mengalir. Terukur pada level tegangan 20 kV arus bocor yang terukur memiliki RMS sebesar 0,0432 A dengan THD sebesar 15,76 % dengan beda fasa arus bocor terhadap tegangan sumber bersifat leading hampir mendekati α = 900. Distribution of electricity in PT PLN PERSERO network, especially in distribution networks often fails due to leakage current in ceramic insulation. The intensity of damage caused by dust pollutants that are attached to the insulation surface, coupled with the humidity of the air in tropical areas such as Indonesia. This cumulatively causes flashover on the insulation surface and causes failure of electricity distribution to the network. The use of Silicon Rubber as an insulating coating can reduce the amount of dust contaminated on the surface, the results show that the voltage parameter will also affect the amount of leakage current flowing to the insulation surface. Higher working voltage will increase the current RMS leakage value. Measured at a voltage level of 20 kV the current leakage was RMS 0.0432 A with THD of 15.76%, phase difference of leakage current to leading source voltage is almost close to α = 900.
Kajian PLTS on–grid pada gedung X Politeknik Negeri Malang untuk melayani beban perkantoran menggunakan perangkat HOMER PRO Priya Surya; Mochammad Junus
JURNAL ELTEK Vol 19 No 2 (2021): ELTEK Vol 19 No 2
Publisher : Politeknik Negeri Malang

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (480.583 KB) | DOI: 10.33795/eltek.v19i2.320

Abstract

Pembangkit Listrik Tenaga Surya (PLTS) dapat diaplikasikan mulai skala kecil sampai skala besar, itu merupakan keunggulan teknologi ini. Dalam skala kecil, pemanfaatan energi surya dapat diaplikasikan di setiap atap rumah untuk memenuhi kebutuhan listrik tiap konsumen residential / rumah tangga. Untuk kebutuhan ini, sistem PLTS dilakukan secara on – grid yaitu terhubung dengan jaringan yang sudah tersedia yaitu jaringan penyedia layanan listrik seperti PLN. Pada penelitian ini, objek penelitian adalah Gedung X pada Politeknik Negeri Malang, dimana kebutuhan bebannya sebesar 12,5 kW dan kebutuhan energi harian 64 kWh. Menggunakan aplikasi HOMER PRO didapatkan untuk sistem dengan skema PV, Baterai, Grid PLN, dan konverter, maka Skematik yang diusulkan pada sistem PLTS adalah menggunakan solar panel dengan total daya terpasang sebesar 11 kWp, dan ditambah dengan baterai sebesar 1500 Ah, konverter daya sebesar 6 kW , dan grid PLN tetap sebagai suplai utama. Untuk bisa mengurangi tagihan listrik, dilakukanlah Renewable Fraction (RF) sebesar 58,5 %, sehingga didapatkan produksi harian untuk solar panel sebesar 45,6 kWh, yaitu sebesar 68 % kebutuhan harian dengan capacity factor sebesar 17,3 %. Solar panel yang digunakan merk ICASOLAR dengan kapasitas 250 Wp membutuhkan sebanyak 44 panel dengan total luasan yang diperlukan sebesar 57 m2 pada atap gedung. Secara ekonomis didapatkan bahwa Net Present Cost pada sistem ini adalah sebesar Rp. 183.000.000,- dan nilai Cost of Energy sebesar Rp. 484,58,- / kWh. PLTS can be applied from small to large scale, that is the advantage of this technology. On a small scale, the use of solar energy can be applied on every roof of the house to meet the electricity needs of each residential / household consumer. For this need, the PLTS system is carried out on an on-grid basis, which is connected to an already available network, namely a network of electricity service providers such as PLN. In this study, the object of research is Building X at the State Polytechnic of Malang, where the load requirement is 12.5 kW and the daily energy requirement is 64 kWh. Using the HOMER PRO application obtained for systems with PV schemes, Batteries, PLN Grids, and converters, the proposed Schematic for the PLTS system is to use solar panels with a total installed power of 11 kWp, and coupled with a 1500 Ah battery, a power converter of 6 kW , and the PLN grid remains as the main supply. To be able to reduce electricity bills, Renewable Fraction (RF) is carried out by 58.5%, so that the daily production for solar panels is 45.6 kWh, which is 68% of daily needs with a capacity factor of 17.3%. The solar panels used by the ICASOLAR brand with a capacity of 250 Wp require 44 panels with a total required area of ​​57 m2 on the roof of the building. Economically, it is found that the Net Present Cost in this system is Rp. 183,000,000,- and Cost of Energy amount Rp. 484,58,- / kWh.