Article Per Year (5 Year)
p-Index From 2019 - 2024
0.444
P-Index
This Author published in this journals
All Journal International Journal of Renewable Energy Development Eksergi
Pradana, Yano Surya
Departemen Teknik Kimia, Fakultas Teknik, Universitas Gadjah Mada
Chemical Engineering, Chemistry & Bioengineering Chemistry Energy

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

 1 
Effect of Devices and Driving Pressures on Energy Requirements and Mass Transfer Coefficient on Microalgae Lipid Extraction Assisted by Hydrodynamic Cavitation Setyawan, Martomo; Mulyono, Panut; Sutijan, Sutijan; Pradana, Yano Surya; Prasakti, Laras; Budiman, Arief
International Journal of Renewable Energy Development Vol 9, No 3 (2020): October 2020
Publisher : Center of Biomass & Renewable Energy, Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14710/ijred.2020.26773

Abstract

Previous studies of biodiesel production from microalgae have concluded that microalgal biodiesel is not profitable at an industrial scale due to its excessive energy consumption for lipid extraction. Hydrodynamic cavitation lipid extraction is one of the extraction methods which has lower energy consumption. Thismethod enables a fast extraction rate and low energy consumption for cell disruption. In order to achieve optimum process conditions, several influential parameters, which are cavitation generator geometry and driving pressure, need to be scrutinized. The experimental result showed that the maximum yield was obtained at 5 bar driving pressure. The lowest specific extraction energy was obtained at 4.167 bar driving pressure while using one side concave cavitation generator geometry with the ratio of the reduced cross-sectional area of 0.39. The value of the energy extraction requirement 17.79 kJoule/g lipids is less than the biodiesel heating value, and the value of the volumetric mass transfer coefficient is almost 20 times fold greater than the conventional extraction method, therefore this method is promising to be further developed.
Pretreatment Spirulina platensis Residue untuk Produksi Bioetanol Heni Anggorowati; Indriana Lestari; Arief Budiman; Yano Surya Pradana
Eksergi Vol 18, No 1 (2021)
Publisher : Prodi Teknik Kimia, Fakultas Teknologi Industri, UPN "Veteran" Yogyakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.31315/e.v0i0.4551

Abstract

Pemerintah Indonesia berusaha untuk menggurangi penggunaan bahan bakar fosil dengan mendorong adanya transisi ke sumber energi terbarukan. Bioetanol merupakan salah satu alternatif energi terbarukan yang mampu mengurangi penggunaan bensin di sektor transportasi. Bioetanol dapat diproduksi dari spirulina platensis residu (SPR) yang masih mengandung karbohidrat yang tinggi. Untuk memaksimalkan perolehan bioethanol diperlukan proses pretreatment yang sesuai untuk memecah dinding sel SPR sehingga diperoleh glukosa yang siap difermentasi. Pada penelitian ini dilakukan tiga metode pretreatment yaitu ultrasonikasi, autoclave dan enzimatis. Pretreatment dengan ultrasonikasi dilakukan dengan ultasonicator batch 40 kHz selama 30 menit dan menghasilkan glukosa sebesar 147,1154 mg/L. Sedangkan dengan autoclave pada suhu 121 oC selama 30 menit menghasilkan glukosa sebesar 21.15385 mg/L. Pretreatmen enzimatis dilakukan dengan menggunakan kombinasi enzim α-amylase dan amyloglucosidase (1:0; 0,75: 0,25; 0,5:0,5; 0,25:0,75 dan 0:1) pada suhu 40 oC selama 180 menit. Yield glukosa maksimum diperoleh pada pengguanaan enzim α-amylase: amyloglucosidase = 0,25:0,75 yaitu sebesar 33,15%.
Co-Authors Arief Budiman Indriana Lestari Martomo Setyawan Panut Mulyono Prasakti, Laras Sutijan