Jurnal Ilmu Lingkungan
Vol 10, No 2 (2012): Oktober 2012

PENGAMBILAN MINYAK KEDELAI DARI AMPAS TAHU SEBAGAI BAHAN BAKU PEMBUATAN BIODIESEL

Buchori, Luqman (Unknown)
Sasongko, Setia Budi (Unknown)
Anggoro, Didi Dwi (Unknown)
Aryanti, Nita (Unknown)



Article Info

Publish Date
05 Nov 2012

Abstract

ABSTRAK Kedelai adalah komoditi terbesar setelah padi di Indonesia. Kebutuhannya mencapai 2,3 juta ton per tahun. Dari jumlah tersebut 50% dikonsumsi berupa tempe, 40% berupa tahu, dan 10% berupa minyak kedelai. Dari produksi tahu, dihasilkan limbah ampas tahu. Dalam penelitian ini, lemak pada ampas tahu diekstraksi untuk mendapatkan minyak kedelai yang dijadikan bahan baku biodiesel. Hasil ekstraksi kemudian dianalisa untuk dibandingkan dengan standar bahan baku biodiesel. Penelitian ini bertujuan untuk menghitung berat lemak yang terekstrak dari ampas tahu terhadap lama waktu ekstraksi dan jenis solven yang digunakan, serta mengetahui komposisi minyak ampas tahu tersebut. Hasil penelitian menunjukan bahwa waktu ekstraksi dan jenis solven mempengaruhi jumlah lemak yang dapat terekstrak. Benzene merupakan solven yang dapat mengekstrak minyak lebih baik daripada solven toluene dan n-heksane. Solven benzene memiliki waktu optimum lima jam untuk mengekstrak lemak yang terdapat di dalam ampas tahu. Dari hasil analisa, diketahui bahwa kadar FFA minyak kedelai yang menggunakan solven benzene sebesar 4,8%, lebih kecil daripada menggunakan solven toluene (5,4%) dan n-heksan (5,8%). Sedangkan bilangan penyabunan diperoleh 184,22 mgKOH/gr untuk benzene, 193,55 mgKOH/gr untuk toluene dan 184,22 mgKOH/gr untuk n-heksan. Kandungan posfor yang didapat sebesar 0,19 untuk benzene, 0,23 untuk toluene dan 0,12% untuk n-heksan. Nilai ini masih dalam kategori besar sehingga harus melewati pretreatment terlebih dahulu sebelum melewati proses transesterifikasi menjadi biodiesel. Kata Kunci: ampas tahu; biodiesel; kedelai; minyak kedelai; transesterifikasi ABSTRACT Soybeans are the largest commodity after rice in Indonesia. Needs to reach 2.3 million tons per year. Of this amount 50% is consumed in the form of tempeh, 40% in the form of knowing, and 10% of soybean oil. From tofu production, tofu waste generated. In this study, fat on tofu extracted for soybean oil used as biodiesel feedstock. The results are then analyzed for compared to standard biodiesel feedstock. This study aimed to calculate the weight of fat extracted from the tofu waste to extraction time and the type of solvent and determines the composition of the oil tofu. The results showed that the extraction time and the type of solvent affects the amount of fat that can be extracted. Benzene is a solvent that can extract oil better than the solvents toluene and n-hexane. Benzene had five hours optimum to extract the fat in the tofu. From the analysis, it is known that the FFA content of soybean oil using benzene was 4.8%, smaller than toluene (5.4%) and n-heksane (5.8%). While these numbers obtained by saponification 184.22 mgKOH/gr for benzene, 193.55 mgKOH/gr for toluene and 184.22 mgKOH/gr for n-heksane. The content of phosphorus of 0.19 for benzene, 0.23 for toluene and 0.12% for n-heksane. This value is still in the major categories that must be passed before pretreatment process trough transesterification into biodiesel. Keywords: tofu waste; biodiesel; soybean; soybean oil; transesterification

Copyrights © 2012