Indonesian Journal of Electrical Engineering and Computer Science
Vol 10, No 2: May 2018

Q-switched Erbium Doped Fiber Laser Incorporating Antimony (III) Telluride in Polyvinyl Alcohol as Saturable Absorber

Ezzatul Irradah Ismail (Malaysia Japan International Institute of Technology (MJIIT), Universiti Teknologi Malaysia)
S Muhammad Ashraf Zolkopli (Malaysia Japan International Institute of Technology (MJIIT), Universiti Teknologi Malaysia)
Muhammad Quisar Lokman (Malaysia Japan International Institute of Technology (MJIIT), Universiti Teknologi Malaysia)
Hafizal Yahaya (Malaysia Japan International Institute of Technology (MJIIT), Universiti Teknologi Malaysia)
Sulaiman Wadi Harun (Department of Electrical Engineering, University of Malaya)
Fauzan Ahmad (Malaysia Japan International Institute of Technology (MJIIT), Universiti Teknologi Malaysia)



Article Info

Publish Date
01 May 2018

Abstract

In this paper, we demonstrated a Q-switched erbium doped fiber laser (EDFL) incorporating Antimony (III) Telluride (Sb2Te3) in polyvinyl alchohol (PVA) as passive saturable absorber.  The saturable absorber were fabricated by dissolving Antimony (III) Telluride powder into PVA solution and dry in the ambient temperature for 48 hours. Then, 1 mm2 x 1 mm2 Sb2Te3-PVA film based saturable absorber were sandwiched in between FC/PC ferrule for Q-switched laser generation. The stable and self-started Q-switched laser operates at center wavelength 1560 nm with 3 dB bandwidth of 0.23 nm. The laser operates at pump power of 29.3 mW until 84.9 mW with repetition rate of 20.99 kHz to 89.29 kHz and pulse width of 13.95 µs to 5.10 µs. At maximum pump power, the laser able to achieve pulse energy of 62.72 nJ and high signal to noise ratio of 71.4

Copyrights © 2018