Wood Research Journal : Journal of Indonesian Wood Research Society
Vol 4, No 1 (2013): Wood Research Journal

Effects of Shelling Ratio and Particle Characteristic on Physical Properties of Three-Layered Particleboard Made from Different Wood Species

Muhammad Navis Rofii (Department of Forest Products Technology Faculty of Forestry Universitas Gadjah Mada Jl. Agro 1 Bulaksumur Yogyakarta 55281)
Satomi Yumigeta (Department of Environment and Forest Resource Science Faculty of Agriculture Shizuoka University Ohya 836, Suruga-ku, Shizuoka 422-8529)
Shigehiko Suzuki (Department of Environment and Forest Resource Science Faculty of Agriculture Shizuoka University Ohya 836, Suruga-ku, Shizuoka 422-8529)
Tibertius Agus Prayitno (Department of Forest Products Technology Faculty of Forestry Universitas Gadjah Mada Jl. Agro 1 Bulaksumur Yogyakarta 55281)



Article Info

Publish Date
19 Apr 2017

Abstract

Wood waste materials such as flakes, particles, sawdust, planer shaving, which are residues from furniture industry can be utilized to manufacture many composites such as particleboard. The most commonly used particleboard has three layers: two face layers and one core layer. The face layers consist of fine particles and the core layer is made of coarse particles.This study aimed to show the effect of shelling ratio and particle characteristic on physical properties of three-layer particleboard with high density core and different particles on surface layers. The materials used in this study were hinoki (Chamaecyparis obtusa) strand and knife-milled Douglas-fir (Pseudotsuga manziesii) as surface layers and hammer-milled matoa (Pometia sp.) as core layer. The wood particles were collected from a wood company. Adhesive used was MDI resin (methylene diphenyl diisocyanate) with 6 % content in mat preparation. The pressing conditions were: temperature 180°C, pressure  3 MPa and pressing time  5 min. The target density was 0.72 g/cm3 with board size of 340 mm x 320 mm  x 10 mm. Factors used in this study were layer structure according to board shelling ratio and particle characteristic. The parameters of this study were density, moisture content, thickness swelling, water absorption, linear expansion and vertical density profile.The results of this study indicate that all boards meet the requirements of JIS A 5908-2003. Higher shelling ratio of surface layers resulted in higher physical performance of three-layer particleboard. In terms of particle type, hinoki strands showed the best performance in board density and linear expansion, while Douglas-fir particle showed the best performance in moisture content, thickness swelling and water absorption. Improvement of physical properties of particleboard with high density wood particles in core layer can be conducted by adding surface layer with higher quality wood particles such as hinoki strands or Douglas-fir particles. Compared to Douglas-fir particles, hinoki strands as surface layers contribute to higher enhancement of three-layer particleboard with matoa as the core layer.

Copyrights © 2013






Journal Info

Abbrev

wrj

Publisher

Subject

Agriculture, Biological Sciences & Forestry

Description

Wood Research Journal is the official journal of the Indonesian Wood Research Society. This journal is an international medium in exchanging, sharing and discussing the science and technology of wood. The journal publishes original manuscripts of basic and applied research of wood science and ...