Journal of Electrical Power Control and Automation (JEPCA)
Vol 5, No 1 (2022): Juni

Rancang Bangun Alat Pengupas Pinang Otomatis Berbasis Arduino Mega

Umirza Fadjar Arpan (Univarsitas Jambi)
Yosi Riduas Hais (Unknown)
Haerul Pathoni (Unknown)

Article Info

Publish Date
02 Jun 2022


Stripping the betel nut using a machine is considered to be more effective than manually, based on this I designed an automatic betel nut peeler control device using Arduino Mega as a mechanical and electrical system controller. In the design of this tool using a hollow iron frame material with 40X40 mm, with a length of 130 cm and a width of 30 cm. Furthermore, this tool is planned to be able to work with a capacity of 20 Kg/hour. After all components are completed, it will proceed to the tool development process to be able to perform performance tests. After testing, stripping using the manual method takes a relatively longer time, which is 11 minutes. While using the machine only takes 6 minutes. In this test, 1 kg or 74 young betel nut, yellow areca nut, dry areca nut, and wet old areca nut were used.

Copyrights © 2022

Journal Info





Electrical & Electronics Engineering


Journal of Electrical Power Control and Automation (JEPCA) rises 2 (two) times a year which is in June and December. The journal publishes articles of research results, and the articles that are entered should not be the result of plagiarism and have not yet been published elsewhere. The article ...