cover
Contact Name
-
Contact Email
-
Phone
-
Journal Mail Official
-
Editorial Address
-
Location
,
INDONESIA
Indonesian Journal of Electrical Engineering and Informatics (IJEEI)
ISSN : 20893272     EISSN : -     DOI : -
Indonesian Journal of Electrical Engineering and Informatics (IJEEI) is a peer reviewed International Journal in English published four issues per year (March, June, September and December). The aim of Indonesian Journal of Electrical Engineering and Informatics (IJEEI) is to publish high-quality articles dedicated to all aspects of the latest outstanding developments in the field of electrical engineering. Its scope encompasses the engineering of Telecommunication and Information Technology, Applied Computing & Computer, Instrumentation & Control, Electrical (Power), Electronics, and Informatics.
Arjuna Subject : -
Articles 8 Documents
Search results for , issue "Vol 3, No 2: June 2015" : 8 Documents clear
Modified Monkey Optimization Algorithm for Solving Optimal Reactive Power Dispatch Problem Kanagasabai Lenin; B.Ravindhranath Reddy; M.Surya Kalavathi
Indonesian Journal of Electrical Engineering and Informatics (IJEEI) Vol 3, No 2: June 2015
Publisher : IAES Indonesian Section

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.52549/ijeei.v3i2.134

Abstract

In this paper, a novel approach Modified Monkey optimization (MMO) algorithm for solving optimal reactive power dispatch problem has been presented. MMO is a population based stochastic meta-heuristic algorithm and it is inspired by intelligent foraging behaviour of monkeys. This paper improves both local leader and global leader phases.  The proposed (MMO) algorithm has been tested in standard IEEE 30 bus test system and simulation results show the worthy performance of the proposed algorithm in reducing the real power loss.
Design of Solar PV Cell Based Inverter for Unbalanced and Distorted Industrial Loads Naga Ananth D; Venkata Nagesh Kumar
Indonesian Journal of Electrical Engineering and Informatics (IJEEI) Vol 3, No 2: June 2015
Publisher : IAES Indonesian Section

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.52549/ijeei.v3i2.136

Abstract

PV cell is getting importance in low and medium power generation due to easy installation, low maintenance and subsidies in price from respective nation. Most of the loads in distribution system are unbalanced and distorted, due to which there will be unbalanced voltage and current occur at load and may disturb its overall performance. Due to these loads voltage unbalance, distorted voltage and current and variable power factors in each phase can be observed. An efficient algorithm to mitigate unbalanced and distorted load and source voltage and current in solar photo voltaic (PV) inverter for isolated load system was considered. This solar PV system can be applicable to remote located industrial loads like heating, welding and small arc furnace type distorted loads and also for unbalanced loads. The PV inverter is designed such that it will maintain nearly constant voltage magnitude and can mitigate harmonics in voltage and current near the load terminals. A MATLAB/ SIMULINK based solar PV inverter was simulated and results are compared with standard AC three phase grid connected system. The proposed shows that the inverter is having very less voltage and current harmonic content and can maintain nearly constant voltage profile for highly unbalanced system.
Influencing Power Flow and Transient Stability by Static Synchronous Series Compensator Md. Imran Azim; Md. Abdul Wahed; Md. Ahsanul Haque Chowdhury
Indonesian Journal of Electrical Engineering and Informatics (IJEEI) Vol 3, No 2: June 2015
Publisher : IAES Indonesian Section

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.52549/ijeei.v3i2.144

Abstract

In the present world, modern power system networks, being a complicated combination of generators, transmission lines, transformers, circuit breakers and other devices, are more vulnerable to various types of faults causing stability problems. Among these faults, transient fault is believed to be a major disturbance as it causes large damage to a sound system within a certain period of time. Therefore, the protection against transient faults, better known as transient stability control is one of the major considerations for the power system engineers. This paper presents the control approach in the transmission line during transient faults by means of Static Synchronous Series Compensator (SSSC) in order to stabilize Single Machine Infinite Bus (SMIB) system.  In this paper, SSSC is represented by variable voltage injection associated with the transformer leakage reactance and the voltage source. The comparative results depict that the swing curve of a system increases monotonically after the occurrence of transient faults However, SSSC is effective enough to make it stable after a while.
Improved Rotor Speed Brushless DC Motor Using Fuzzy Controller Jafar Mostafapour; Jafar Reshadat; Murtaza Farsadi
Indonesian Journal of Electrical Engineering and Informatics (IJEEI) Vol 3, No 2: June 2015
Publisher : IAES Indonesian Section

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.52549/ijeei.v3i2.147

Abstract

A brushless DC (BLDC) Motors have advantages over brushed, Direct current (DC) Motors and , Induction motor (IM). They have better speed verses torque characteristics, high dynamic response, high efficiency, long operating life, noiseless operation, higher speed ranges, and rugged construction. Also, torque delivered to motor size is higher, making it useful in application where space and weight are critical factors. With these advantages BLDC motors find wide spread application in automotive appliance, aerospace medical, and instrumentation and automation industries This paper can be seen as fuzzy controllers compared to PI control BLDC motor rotor speed has improved significantly and beter result can be achieve.
Simulation Time and Energy Test for Topology Construction Protocol in Wireless Sensor Networks Satyam Gupta; Gunjan Gupta
Indonesian Journal of Electrical Engineering and Informatics (IJEEI) Vol 3, No 2: June 2015
Publisher : IAES Indonesian Section

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.52549/ijeei.v3i2.139

Abstract

Coverage area and energy consumption are very big challenges in the field of Wireless Sensor Networks (WSNs) as it affects the number of sensors, connectivity and network. Since the sensors are operating on battery of limited power, it is a challenging aim to design an energy efficient Topology Control protocol, which can minimize the energy and thereby extend the lifetime of the network. Through this paper an attempt has been made in terms of simulation time and spent energy in construction of topology in the sensor network by comparing Just Tree and K-neigh Tree protocols. The result shows that K-neigh Tree protocol consumes less energy than Just Tree protocol.
A New Approach to Adaptive Signal Processing Muhammad Ali Raza Anjum
Indonesian Journal of Electrical Engineering and Informatics (IJEEI) Vol 3, No 2: June 2015
Publisher : IAES Indonesian Section

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.52549/ijeei.v3i2.143

Abstract

A unified linear algebraic approach to adaptive signal processing (ASP) is presented. Starting from just Ax=b, key ASP algorithms are derived in a simple, systematic, and integrated manner without requiring any background knowledge to the field.  Algorithms covered are Steepest Descent, LMS, Normalized LMS, Kaczmarz, Affine Projection, RLS, Kalman filter, and MMSE/Least Square Wiener filters. By following this approach, readers will discover a synthesis; they will learn that one and only one equation is involved in all these algorithms. They will also learn that this one equation forms the basis of more advanced algorithms like reduced rank adaptive filters, extended Kalman filter, particle filters, multigrid methods, preconditioning methods, Krylov subspace methods and conjugate gradients. This will enable them to enter many sophisticated realms of modern research and development. Eventually, this one equation will not only become their passport to ASP but also to many highly specialized areas of computational science and engineering.
A Document Imaging Technique for Implementing Electronic Loan Approval Process J. Manikandan; C.S. Celin; V.M. Gayathri
Indonesian Journal of Electrical Engineering and Informatics (IJEEI) Vol 3, No 2: June 2015
Publisher : IAES Indonesian Section

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.52549/ijeei.v3i2.146

Abstract

The image processing is one of the leading technologies of computer applications. Image processing is a type of signal processing, the input for image processor is an image or video frame and the output will be an image or subset of image [1]. Computer graphics and computer vision process uses an image processing techniques. Image processing systems are used in various environments like medical fields, computer-aided design (CAD), research fields, crime investigation fields and military fields. In this paper, we proposed a document image processing technique, for establishing electronic loan approval process (E-LAP) [2]. Loan approval process has been tedious process, the E-LAP system attempts to reduce the complexity of loan approval process. Customers have to login to fill the loan application form online with all details and submit the form. The loan department then processes the submitted form and then sends an acknowledgement mail via the E-LAP to the requested customer with the details about list of documents required for the loan approval process [3]. The approaching customer can upload the scanned copies of all required documents. All this interaction between customer and bank take place using an E-LAP system.
Notice of Retraction Monitoring and Controlling of Industrial Crane using Programmable Logic Controllers Harpreet Singh Bedi; Krishan Arora
Indonesian Journal of Electrical Engineering and Informatics (IJEEI) Vol 3, No 2: June 2015
Publisher : IAES Indonesian Section

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.52549/ijeei.v3i2.145

Abstract

Notice of Retraction-----------------------------------------------------------------------After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IAES's Publication Principles.We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.The presenting author of this paper has the option to appeal this decision by contacting ijeei.iaes@gmail.com.-----------------------------------------------------------------------In this paper, we will work on Programmable logic Controllers to control the operation of An Industrial Crane and many other Applications which is used in the industry. Earlier in Industry, We used certain control devices which were controlled and wired directly with the system that leads to certain irregularity in the functioning of the whole system. To overcome the in-functionality of the system which was caused by large number of wires, We came cross towards Programmable logic controllers (PLC).Earlier Human controls the crane & that passes through large drawbacks such as more wiring work, appears large mechanical faults & difficulties in troubleshooting & repair work .Due to these Drawbacks the production suffers a lot and hence growth decreases rapidly.

Page 1 of 1 | Total Record : 8