<![CDATA[The purpose of this research is to design PID control on BLDC motors using 2 tuning methods, namely Cohen-Coon and Trial & Error. PID control of formula calculations with calculations in Simulink Matlab. From the simulation results shown in graphical form, the use of the PID control gives a better effect than the use of the P and PI controls. This can be seen in the comparison curve which shows the speed of the initial start process when using the PID control. In the Trial & Error method, the response value of the system to controller P is obtained, namely, rise time = 0.0151 s, settling time = 0.6 s, overshoot = 75.9%, peak time = 1.74 s, and time delay = 0.424 s. on the PI controller namely, rise time = 0.0148 s, settling time = 0.591 s, overshoot = 76.3%, peak time = 1.74 s, and time delay = 0.0416 s. on the PID controller namely, rise time = 0.0496 s, settling time = 0.55 s, overshoot = 44 %, peak time = 1.31 s, and time delay = 0.128 s. In the Cohen-Coon method, the response value of the system to controller P is obtained, namely, rise time = 0.0168 s, settling time = 0.575 s, overshoot = 73.3%, peak time = 1.71 s, and time delay = 0.0469 s. on the PI controller namely, rise time = 0.0573 s, settling time = 0.603 s, overshoot = 39.3%, peak time = 1.23 s, and time delay = 0.142 s. on the PID controller namely, rise time = 0.276 s, settling time = 0.658 s, overshoot = 2.42 %, peak time = 0.159 s, and time delay = 0.576 s. From the simulation results it is shown that the value for the Cohen-Coon tuning method is better than the Trial & Error method, perhaps because the input value for the Trial & Error method is larger.]]>
Copyrights © 2023
