Article Per Year (5 Year)
p-Index From 2019 - 2024
0.408
P-Index
This Author published in this journals
All Journal J-Dinamika: Jurnal Pengabdian Kepada Masyarakat Jurnal Engine: Energi, Manufaktur, dan Material
Ismail, Andhi Akhmad
Unknown Affiliation
Control & Systems Engineering Education Energy Industrial & Manufacturing Engineering Materials Science & Nanotechnology Mechanical Engineering

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search
Journal : Jurnal Engine: Energi, Manufaktur, dan Material

 1 
Pengaturan Kecepatan Spindle Mesin Bubut Retrofit Menggunakan VSD (Variable Speed Drive) Ismail, Andhi Akhmad; Hendaryanto, I. Aris
Jurnal Engine: Energi, Manufaktur, dan Material Vol. 8 No. 1 (2024)
Publisher : Proklamasi 45 University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.30588/jeemm.v8i1.1672

Abstract

Retrofitted milling machines are usually not equipped with a gear box to control spindle rotation, so they will experience difficulties if varied spindle shaft rotation is desired. The commonly used way to adjust the rotation of the spindle shaft so that it can vary is by adjusting the rotation of the spindle drive induction motor using a Variable Speed Drive (VSD). The research started by removing the old single phase induction motor and replacing it with a three phase induction motor, then creating a control circuit so that the VSD could work automatically with commands from the breakout board. The rotation adjustment is carried out using a potentiometer installed on the VSD. Spindle shaft rotation is detected using a pulse meter which gets a signal from an inductive proximity sensor and is installed on the spindle shaft. Experiments during the research showed that the spindle rotation could be adjusted using VSD properly, starting from a speed of 0 rpm to 2000 rpm. The spindle experiences a decrease in speed when subjected to a load, most likely due to slippage that occurs from the drive pulley which is rotated by the drive induction motor to the spindle pulley because it uses a belt transmission.
Co-Authors Bahari, Galuh Ignatius Aris Hendaryanto Krisnaputra, Radhian Nur Esa, Suhada Nur Hidayatulloh, Fikhih Sugiyanto - Winarto, Felik Eko Wismo