Article Per Year (5 Year)
p-Index From 2019 - 2024
0.817
P-Index
This Author published in this journals
All Journal International Journal of Electrical and Computer Engineering International Journal of Power Electronics and Drive Systems (IJPEDS)
Anas Lateef Mahmood
Al-Nahrain University
Computer Science & IT Control & Systems Engineering Electrical & Electronics Engineering

Published : 4 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 4 Documents
Search

 1 
An optimum location of on-grid bifacial based photovoltaic system in Iraq Amina Mahmoud Shakir; Siba Monther Yousif; Anas Lateef Mahmood
International Journal of Electrical and Computer Engineering (IJECE) Vol 12, No 1: February 2022
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijece.v12i1.pp250-261

Abstract

Bifacial photovoltaic (PV) module can gain 30% more energy compared to monofacial if a suitable location were chosen. Iraq (a Middle East country) has a variable irradiation level according to its geographic coordinates, thus, the performance of PV systems differs. This paper an array (17 series, 13 parallel) was chosen to produce 100 kWp for an on-grid PV system. It investigates the PV system in three cities in Iraq (Mosul, Baghdad, and Basrah). Effect of albedo factor, high and pitch of the bifacial module on energy yield have been studied using PVsyst (software). It has been found that the effect is less for a pitch greater than 6 m. The energy gained from bifacial and monofacial PV system module in these cities shows that Mosul is the most suitable for installing both PV systems followed by Baghdad and lastly Basrah. However, in Basrah, the bifacial gain is 12% higher in the energy than monofacial as irradiation there is higher than the other locations, especially for elevation above 1.5 m. Moreover, the cost of bifacial array is 7.23% higher than monofacial, but this additional cost is acceptable since the bifacial gain is about 11.3% higher energy compared to the monofacial.
Design and simulation of stand-alone photovoltaic system supplying BTS in Iraq Saja Mazin Sami; Anas Lateef Mahmood
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 12, No 1: March 2021
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijpeds.v12.i1.pp463-473

Abstract

The problem of power outages is still present in most cities of Iraq as a result of the wars and crises experienced by Iraq and this makes it difficult to provide continuous electric power to the electrical devices. All telecommunications companies, including Zain, Asia cell, etc in Iraq used diesel generators as an alternative source to the national electricity grid, but this will adversely affect the environment and humans as a result of toxic emissions associated with the use of these generators. In this paper, a stand-alone PVsystem was designed and simulated to supply a base transceiver station (BTS) in Iraq. A BTS in Jadriyah, Baghdad with 4.177 kW load power belong to Zain Telecommunication Company was taken as a case study in this paper. The meteorological data of the Jadriyah region were taken from a weather station belong to the ministry of Sciences and Technology in Iraq for the year 2017. The simulation for this BTS was carried out using the Pvsyst simulation program. The financial analysis of the proposed system shows that it has small kWh unit price (0.108 $/kWh).
Design and performance analysis of stand-alone PV system at Al-Nahrain University, Baghdad, Iraq Anas Lateef Mahmood; Amina Mahmood Shakir; Bahaa Abdulkhaliq Numan
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 11, No 2: June 2020
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (659.01 KB) | DOI: 10.11591/ijpeds.v11.i2.pp921-930

Abstract

The use of the stand-alone PV systems for electric power generation is important to meet the needs of electric power, especially in countries that have major problems in the generation and continuity of electricity such as Iraq. The aim of this research is to design and simulate a stand-alone PV system installed on the roof of the parking garage in the College of Engineering at Al-Nahrain University for the purpose of using the electrical energy generated by this system to meet the energy demand of the daily light for the parking garage and engineering laboratories buildings beside it. The main factor in the design was the total area of the roof of the parking garage. The Pvsyst6 program is used to simulate the suggested PV system and to determine the effect of partial shading which caused by the trees surrounding the garage on the available generated power of the system. A comparison was made between four types of solar panels to see the suitability of these types to the weather conditions in Iraq, in addition to the impact of the shadows surrounding the garage. These types of solar panels were (CIS SL2-145, CdTe F-4112-3, Poly JAP6-60-260, and Mono JAM6-60-260), CdTe type showed better performance compared to other types in terms of available energy generated because it has small losses due to temperature and shadows. It was found that the best tilt angle of the solar panels in the case of shadows is 19o to the south. Finally, the financial analysis was made to see the economic feasibility of this PV system and it is found that the PV system that uses CdTe panels has the smallest kWh unit price (0.236 $/kWh) as compared with the other three types.
Photovoltaic array maximum power point tracking via modified perturbation and observation algorithm Bahaa Abdulkhaliq Numan; Amina Mahmoud Shakir; Anas Lateef Mahmood
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 11, No 4: December 2020
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijpeds.v11.i4.pp2007-2018

Abstract

One drawback of PVs is their low efficiency. As the PVs have a unique maximum Power Point for a specified irradiation level, there must be an effective method for extracting maximum power from the PV module to raise the efficiency. Conventional Perturbation and Observation (P&O) is a simple algorithm for maximum power point tracking (MPPT) but it suffers from oscillation during steady state conditions and is deviated from the maximum power point during slow and rapid irradiation level change. This paper presents a modified P&O by adding variation in PV current as a third in addition to the voltage and power variation parameters. This new algorithm is capable of eliminating the MPPT deviation. To increase the perturbation speed, a double step is taken as the tracking is deviated from the MPP. The modified P&O algorithm is used to control the duty cycle of DC-DC buck converter. The simulation shows that the modified P&O is faster than the conventional. The power loss due to oscillation before attaining the steady state is less for modified P&O. For slow irradiation level change (ramp up 600 to 1000 and ramp down 1000-800) W/m2, the modified P&O shows less tracking diverge. As the irradiation level changes rapidly from 800 to 200 W/m2, it's shown that the modified algorithm attains the steady state faster than the conventional P&O and the average efficiency increased by 4.34%.
Co-Authors Amina Mahmood Shakir Amina Mahmoud Shakir Bahaa Abdulkhaliq Numan Saja Mazin Sami Siba Monther Yousif