Claim Missing Document
Check
Articles

Found 2 Documents
Search

PENGEMBANGAN ENERGI TERBARUKAN HYBRID THERMOELECTRICS DENGAN MEMANFAATKAN PANAS MATAHARI DARI KOLEKTOR PARABOLA SILINDRIS Defrianto Defrianto; Eri Wiyadi; Lazuardi Umar
Komunikasi Fisika Indonesia Vol 18, No 3 (2021)
Publisher : Universitas Riau

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.31258/jkfi.18.3.167-172

Abstract

Pembangkit energi listrik Thermoelectric Generator tipe 10W-4V-40s bekerja melalui perbedaan suhu dikedua sisinya. Sisi panas (Th) dari sebuah elemen TEG diletakan pada dudukan yang terbuat dari bahan Alumunium Dural dan diberi sumber panas yang berasal dari kolektor surya parabola, pada sisi dingin (Tc) elemen TEG dipasang heatsink guna mengurangi energi panas yang menembus sisi dingin serta menjaga suhunya agar tetap rendah, hasil dari penelitian menunjukan bahwa Kolektor surya parabola dalam penelitian ini mampu menghasilkan suhu maksimum sebesar 64,2 °C. Tegangan Voc maksimum yang dihasilkan dari penelitian adalah sebesar 1,087 V selain itu tegangan beban Vo terhadap variasi hambatan beban RL pada suhu Th 40 °C dan suhu sisi dingin Tc 32 °C  adalah 459, 47 mV pada R­L 20 Ω., arus beban maksimum yang diperoleh adalah 125,97 mA pada RL 0,5 Ω dan cendrung turun seiring bertambahnya RL yaitu sebesar 23,63 mA pada RL 20 Ω. Nilai tegangan VL dan IL paling besar terletak pada saat receiver berada pada ketinggian 17,5 cm atau tepat berada pada titik fokus reflektor, yaitu sebesar 120,90 mV dan 31,87 mA dengan ∆T sebesar 25 °C.
PENGARUH HAMBATAN INTERNAL TERHADAP DAYA OUTPUT ELEMEN TERMOELEKTRIK GENERATOR TIPE 10W-4V-40s Eri Wiyadi; Lazuardi Umar
Komunikasi Fisika Indonesia Vol 15, No 1 (2018)
Publisher : Universitas Riau

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (92.796 KB) | DOI: 10.31258/jkfi.15.1.67-70

Abstract

Thermoelectric generator Type 10W-4V-40s powered by Seebeck effect by utilizing temperature difference in both sides of the element. The hot side (Th) of a TEG element is placed on a stand made of Aluminum-Dural material and given a heat source derived from a heater, on the cold side (Tc) TEG element installed heatsink to reduce heat energy through the cold side and keep the temperature low. The measurement of output power (PL) is done by variation of RL from 0 Ω to 20 Ω under temperature difference conditions (ΔT) varies with constant Tc at 30ºC, the result of the research indicates that the output power (PL) of the thermoelectric element is maximum at RL = 1 Ω when the minimum load decreases and is proportional to the increase in RL resistance. The internal resistance value (Rint) of the TEG element increases in proportion to the magnitude of ΔT on both sides of the element, on Tc and Th at room temperature (30ºC) the value of Rint is 0.85 Ω and the maximum value at ΔT = 50ºC is 1,043 Ω. This indicates that the TEG element depends not only on ΔT on both sides of the module, but also depends on the amount of temperature range used.