Claim Missing Document
Check
Articles

Found 4 Documents
Search

PERANCANGAN SISTEM INSTALASI DAYA LISTRIK PABRIK BIOETHANOL DI NGADIREJO-KEDIRI Hary Purwanto; Ishak Kasim
Jetri : Jurnal Ilmiah Teknik Elektro Jetri Volume 16, Nomor 2, Februari 2019
Publisher : Website

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (290.729 KB) | DOI: 10.25105/jetri.v16i2.2979

Abstract

PT Perkebunan Nusantara X (PTPN X) merupakan suatu perusahaan milik pemerintah yang sedang mempersiapkan dan akan melaksanakan pembangunan sebuah pabrik “EPCC Pabrik Bioethanol kapasitas 100 KLPD” di Pabrik Gula Ngadiredjo-Kediri yang akan disuplai dengan Pembangkit Listrik Tenaga Biomass (PLTBm)-Cogeneration dengan kapasitas 20 MW dan Turbine Generator 3000 kW. Dalam hal ini, pabrik membutuhkan suatu perancangan sistem instalasi daya lisrik agar bisa beroperasi baik. Pada penelitian ini akan membahas tentang perancangan sistem instalasi daya listrik pabrik terserbut. Untuk menunjang perancangan sistem instalasi daya listrik ini, diperlukan data beban pabrik (load list) yang terdapat pada lampiran 1 yang berguna untuk menganalisa dan memperhitungkan seberapa besarnya rating arus pengaman, luas penghantar (kabel),  transformator 3 fasa dan bagaimana bentuk Single Line Diagram (SLD) yang akan digunakan oleh pabrik. Pada perancangan sistem instalasi daya listrik pabrik, hasil perhitungan dan analisa dari beban-beban pabrik dan rancangan Single Line Diagram (SLD) yang digunakan mengacu pada peraturan dan ketentuan berdasarkan PUIL 2011 dengan standar yang digunakan adalah SNI (Standar Nasional Indonesia). Kata kunci : Instalasi listrik, Daya listrik, Kabel.
Sistem PLTS untuk Pompa Air Irigasi Pertanian di Kota Depok Sevira Rambanisa Hamzah; Chairul G Irianto; Ishak Kasim
Jetri : Jurnal Ilmiah Teknik Elektro Jetri, Volume 17, Nomor 1, Agustus 2019
Publisher : Website

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (460.71 KB) | DOI: 10.25105/jetri.v17i1.4788

Abstract

Located in the tropical region, Indonesia has great potential for solar power plants. This can be used as an alternative energy to meet electricity needs that are useful for managing agricultural land. This paper discusses the stand alone PV design for a water pump that has an output discharge of 60 liters per minute which will be used for planting water spinach plants in an area of 100 m2 in the Pancoran Sub-district, Depok City. The results show that to meet the pump electricity needs, it takes two PVs each with 80 W power capacity,  one solar charge controller unit with 20 A capacity, and one battery unit with 100 Ah capacity. The average output power is 72.35 Wh with 18.68% efficiency. Terletak di daerah tropis, Indonesia memiliki potensi yang besar untuk pembangkit listrik tenaga surya. Hal ini dapat dimanfaatkan sebagai salah satu energi alternatif untuk memenuhi kebutuhan listrik  yang berguna untuk mempermudah pengelolaan lahan pertanian. Makalah ini membahas mengenai desain stand alone PV untuk pompa air yang memiliki debit keluaran sebesar 60 liter per menit yang digunakan untuk irigasi tanaman kangkung pada area seluas 100m2 di Kecamatan Pancoran, kota Depok. Hasil menunjukan bahwa untuk memenuhi kebutuhan listrik pompa air, dibutuhkan dua buah PV dengan kapasitas masing-masing sebesar 80 W, satu unit solar charge controller dengan kapasitas 20 A, dan satu unit baterai dengan kapasitas 100 Ah. Daya keluaran rata-rata adalah sebesar 72,35 Wh dengan efisiensi 18,68%.
Aplikasi Sistem Pompa Air Tenaga PV Surya Atap 2x150 Wp Untuk Kantin Karfati Di Gedung E, Universitas Trisakti Chairul Gagarin Irianto; Maulasukma Widjaya; ishak kasim; syamsir Abduh; Dianing Novita Nurmala Putri
Jetri : Jurnal Ilmiah Teknik Elektro Jetri, Volume 18, Nomor 2, Februari 2021
Publisher : Website

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (536.614 KB) | DOI: 10.25105/jetri.v18i2.9345

Abstract

In this study, a simple, consumable water purification system with a photovoltaic (PV) solar domestic ac motor has been designed and implemented in the Karfati canteen, E Building, Campus A, Usakti. The single-phase ac pump motor, 135Watt is used to transfer water from the storage pool to the temporary storage tank and then filter it by gravity, it is flowed through the pipe to the clean water storage tank before being distributed to ten canteen kiosk. The optimum solar panel is chosen according to the calculation of the maximum power required by the motor. The energy needs of the pump motor have been provided from solar panels and batteries through an inverter. Fixed installation of solar PV panels on the roof of building E facing 15 degrees north to optimize radiation efficiency of the system. The selection of an inverter system that matches the characteristics of the ac pump engine is developed to ensure the supply of the ac pump motor when it is started safely. Optimization of the solar PV water pump system is equipped with an array of 2 2x150 Wp PV modules, 500 VA inverters, 100 Ah batteries to supply 135 W, 220V, 50Hz pump engine power to produce clean water around 1000 liters per day in the Karfati canteen.Dalam penelitian ini, sistem penjernihan air sederhana layak konsumsi dengan motor ac domestik tenaga photovoltaic (PV) surya telah dirancang dan diterapkan di kantin Karfati Gedung E, Kampus A, Usakti. Motor pompa ac satu fasa, 135Watt digunakan untuk memindahkan air baku dari kolam penampungan ke tangki penyimpanan sementara dan selanjutnya memfiltrasinya secara grafitasi dialirkan melalui pipa ke tangki penyimpanan air bersih sebelum didistribusikan ke sepuluh kiosk kantin. Panel surya optimum dipilih sesuai perhitungan daya maksimum yang dibutuhkan motor. Kebutuhan energi motor pompa telah disediakan dari panel surya dan baterai melalui inverter. pemasangan fix panel pv surya di atap gedung E menghadap utara 15 derajat untuk mengoptimalkan radiasi efisiensi sistem. Pemilihan system inverter yang sesuai karakteristik mesin pompa ac dikembangkan untuk menjamin suplai motor pompa ac saat diasut dengan aman. Optimalisasi sistem pompa air tenaga PV surya dilengkapi dengan array dari 2 modul pv 2x150 Wp, inverter 500 VA, baterai 100 Ah mencatu daya mesin pompa 135 W, 220V, 50Hz untuk memproduksi air bersih sekitar 1000 liter per hari di kantin Karfati. .  
A Deteksi Kekurangan Pelumas Bearing untuk Mencegah Kerusakan pada Motor Induksi Kompresor Udara Varel Farhan Cachandra; Chairul Gagarin Irianto; Ishak Kasim; Tyas Kartika Sari
Jetri : Jurnal Ilmiah Teknik Elektro Jetri, Volume 20, Nomor 2, Februari 2023
Publisher : Website

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.25105/jetri.v20i2.15597

Abstract

The induction motor is one of the most important parts in the industrial world today, so if an induction motor is damaged it can affect the production process. Therefore, disturbances that exist in induction motors must be predicted or detected as early as possible. One of the causes of bearing damage is lack of lubrication which can cause an increase in motor temperature, noise, vibration and sparks which can cause damage to other parts of the induction motor. So the authors will conduct research using four different parameters namely starting current, vibration, and temperature on Air Compressor motors whose maintenance treatment in re-lubrication is carried out differently. In this study it was found that if the lubrication on the bearings is not maintained properly then the vibration value is very high at 23 to 24 mm/s, the starting current itself increases up to 8 times the nominal current where this can cause large voltage losses, the current is above the nominal current of the motor, which is 133% of the nominal current, with dry lubrication on the bearings of the induction motor, friction cannot be minimized so that the temperature of the motor increases where data is obtained on the temperature rise of the induction motor for 5 minutes the motor works at 74.3⁰ C and this can endanger the induction motor itself, it can be concluded that the lack of lubrication on induction motor bearings affects 4 parameters mentioned before. Keywords: 3 phase induction motor, Air Compressor, Bearing, Lubrication Oil, Vibration