Article Per Year (5 Year)
p-Index From 2019 - 2024
0.408
P-Index
This Author published in this journals
All Journal Jurnal Elektronika dan Telekomunikasi
Salita Ulitia Prini
Research Center for Electronics and Telecommunication National Research and Innovation Agency (BRIN)
Electrical & Electronics Engineering Engineering

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

 1 
Optimization of Low Site Density Area for 4G Network in Urban City Hajiar Yuliana; Sofyan Basuki; Salita Ulitia Prini
Jurnal Elektronika dan Telekomunikasi Vol 21, No 2 (2021)
Publisher : LIPI Press

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14203/jet.v21.98-103

Abstract

The development of telecommunications is currently growing rapidly, especially in urban areas. To obtain optimal data services for users, the performances of 4G network services must continue to be optimized. It is known that many users are scattered in urban areas, but sometimes it is not balanced with an even distribution of the site in this area. This condition occurs because the distribution of the site is not evenly optimal distributed, either due to licensing constraints, limited land access for site development, or in terms of plans that have not been made. Balanced with the requirement of a 4G network, which is required, this "empty space" condition or low site density condition must find a solution or optimize it. Many optimization methods can optimize the area with low site density possibility. This study will optimize the area by adding a new site proposal based on coverage planning. We need to analyze Reference Signal Received Power (RSRP) coverage signal distribution using Atoll Planning Software. After optimization, the RSRP level below or equal -80 dBm increased from 75.195% to 94.08%. Furthermore, the percentage calculation for inadequate coverage (below -80 dBm) decreased from 24.816% to 5.931%. This RSRP signal level also shows that the condition after optimization with a new site can improve the signal level condition from areas with low site density possibility.
Analytical Performance of Low Noise Amplifier Using Single-Stage Configuration for ADS-B Receiver M. Reza Hidayat; Ilham Pazaesa; Salita Ulitia Prini
Jurnal Elektronika dan Telekomunikasi Vol 21, No 2 (2021)
Publisher : LIPI Press

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14203/jet.v21.91-97

Abstract

Automatic dependent surveillance-broadcast (ADS-B) is an equipment of a radar system to reach difficult areas. For radar applications, an ADS-B requires a low noise amplifier (LNA) with high gain, stability, and a low noise figure. In this research, to produce an LNA with good performance, an LNA was designed using a BJT transistor 2SC5006 with DC bias, VCE = 3 V, and current Ic = 10 mA, also a DC supply with VCC = 12 V, to achieve a high gain with a low noise figure. The initial LNA impedance circuit was simulated using 2 elements and then converted into 3 elements to obtain parameters according to the target specification through the tuning process, impedance matching circuit was used to reduce return loss and voltage standing wave ratio (VSWR) values. The LNA sequence obtains the working frequency of 1090 MHz, return loss of -52.103 dB, a gain of 10.382, VSWR of 1.005, a noise figure of 0.552, stability factor of 0.997, and bandwidth of 83 MHz. From the simulation results, the LNA has been successfully designed according to the ADS-B receiver specifications.
Co-Authors Hajiar Yuliana Ilham Pazaesa M. Reza Hidayat Sofyan Basuki