Jurnal Rekayasa Mesin
Vol. 21 No. 1 (2021): Jurnal Rekayasa Mesin

Perancangan dan Pembuatan Mesin Bending dan Notching

Muhammad Yanis (Jurusan Teknik Mesin Universitas Sriwijaya)
gunawan (Jurusan Teknik Mesin Universitas Sriwijaya)
Ricky Wahyu Pratama (Unknown)

Article Info

Publish Date
01 Mar 2021


Bending and notching is a common process in manufacturing world as in vehicles chassis fabrication. But, the recent problem is the limited tools that needed to bend and notch pipes. The objective of this research is to fabricate a tool or production machine that could bend and notch pipes based on need by using three roll bending method. As for the notching angle of 0  to 60  and the diameter for notching cutting is 1 to 2 inch. There are some calculations on machine structure by using solidworks simulation such as stress analysis, von mises and factor of safety. There are three trials in bending process such as deflection from 1, 2 and 3 cm and on the other side, notching trials start from 0  to 60 . This notching and bending machine created with two functions. The bending process is conducted in the middle part while the notching process is in the top part of the machine. This machine has 70 cm length, 50 cm wide and 120 cm height and the total amount of cost spent for this machine is Rp. 9.009.500.

Copyrights © 2021

Journal Info





Aerospace Engineering Automotive Engineering Control & Systems Engineering Energy Engineering Industrial & Manufacturing Engineering Materials Science & Nanotechnology Mechanical Engineering


Jurnal Rekayasa Mesin (JRM) Jurusan Teknik Mesin Universitas Sriwijaya adalah sebuah jurnal blind peer-review yang didedikasikan untuk publikasi hasil penelitian yang berkualitas dalam bidang ilmu Teknik Mesin namun tak terbatas secara implisit. Semua publikasi di Jurnal Rekayasa Mesin ini bersifat ...