Journal of Mechanical and Manufacture
Vol 2 No 1 (2022)

PROCESS FOR MAKING TURBINE PROPELLER SHAFT USING ST.37 LOW CARBON STEEL MATERIALS AT THE INDONESIAN INSTITUTE OF KNOWLEDGE (LIPI)

Mohamad Fajri Hamdani (Universitas Majalengka)
Eidelweis Dewi Jannati (Universitas Majalengka)

Article Info

Publish Date
01 Oct 2022

Abstract

The shaft is a rotating stationary member, usually spherical in cross section, the shaft may receive bending loads, tensile loads, compressive loads or torsional loads acting alone or in combination with one another. The propeller turbine shaft is made using a conventional lathe from the Indonesian Institute of Sciences (LIPI). The shafts made have stratified diameters with diameters of 8 mm, 10 mm, 15 mm and 24 mm with an overall length of 595 mm and has a thread in one part of the shaft. The axle uses ST.37 material, dural rod material and for the outside of the shaft (casing) using aluminum. Dural is a high strength aluminum based alloy with the addition of copper, magnesium and manganese.

Copyrights © 2022




Citation Download
RIS
EndNote, Reference Manager, ProCite
BibTex
Latex, Jabref
Full PDF
1051.876 KB
Original Source
Download Original
Google Scholar
Check in Google Scholar
Journal Info
Journal of Mechanical and Manufacture
Website

Abbrev

jmm

Publisher

Universitas Majalengka

Subject

Aerospace Engineering Automotive Engineering Control & Systems Engineering Electrical & Electronics Engineering Industrial & Manufacturing Engineering Mechanical Engineering

Description

Journal Of Mechanical And Manufacture (JMM) published 2 (two) times a year . Since 2022, the JMM published in March and September . Contents of the journal discusses the results of research in the field of manufacture engineering, industrial engineering and mechanical ...