Journal of Mechanical Engineering Science and Technology
Vol 1, No 2 (2017)

Compositional and Structural Evolution during Ball Milling of Ti-based Metallic Glass Powder

Yanuar Rohmat (Department of Mechanical Engineering, State University of Malang, Malang City, East Java, Indonesia)

Article Info

Publish Date
03 Nov 2017

Abstract

Ti42Zr40Ta3Si7.5Sn7.5metallic glass powder prepared for subsequent consolidation by hot pressing were produced by high energy ball milling from amorphous ribbon and both of the compositional and structural evolution on milled powders were studied using XRD and DSC analyses. By using WC vial and balls, the abrasion of milling media occurred causing WC contamination on < 105 µm milled powder after 2 cycles of milling. Based on DSC analysis, the contamination clearly reduced theΔTxof the alloy up to 48%. On the other hand, the contamination were overcome after milling using SS vial and balls, proved by no crystal peak observed on XRD pattern of all milling cycle levels. However, the thermal stability was noticed to be decreased implying the presence of nanocrystals on the amorphous powder after ball milling and the nanocrystal amount tend to be higher when more milling cycles were applied.

Copyrights © 2017




Citation Download
RIS
EndNote, Reference Manager, ProCite
BibTex
Latex, Jabref
Full PDF
954.813 KB
Original Source
Download Original
Google Scholar
Check in Google Scholar
Journal Info
Journal of Mechanical Engineering Science and Technology
Website

Abbrev

jmest

Publisher

Universitas Negeri Malang

Subject

Energy Engineering Industrial & Manufacturing Engineering Materials Science & Nanotechnology Mechanical Engineering

Description

Journal of Mechanical Engineering Science and Technology (JMEST) is a peer reviewed, open access journal that publishes original research articles and review articles in all areas of Mechanical Engineering and Basic ...