Mohammad Javad Kiani
Islamic Azad University

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

Design of a new backstepping controller for control of microgrid sources inverter Mahmoud Zadehbagheri; Mohammad Javad Kiani; Tole Sutikno; Rasoul Arvin Moghadam
International Journal of Electrical and Computer Engineering (IJECE) Vol 12, No 4: August 2022
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijece.v12i4.pp4469-4482

Abstract

Emergency power supply is becoming an important capability for many home or industrial electronic and computer devices. Therefore, the performance of the designed uninterruptible power supplies (UPS) inverters has low distortion at the output voltage. Initially, such inverters were controlled by proportional integral (PI) control classic rules. This method is difficult to understand the limitations of stability and to apply transient response to strong external disturbances. In this paper, an inverter is simulated and offered for single-phase and three-phase voltage controlled by a non-linear controller. For this purpose, a comparison has been made between the controller performance and the PI controller. In the first step, there is a backstepping regulator that uses the stability tool next to the Lyapunov function. And the other regulator operates according to the PI method. The performance of these two regulators is simulated during a change in reference or a load change in MATLAB. Also, a method of feedback voltage control based on the Lyapunov theory for controlling of the distributed generation (DG) unit independent Inverter is presented. The proposed controller is not only simple, but also against the sudden changes in load and the unspecified system is resistant.
Comparative detection and fault location in underground cables using Fourier and modal transforms Vahdat Nazerian; Mohammad Esmail Zakerifar; Mahmoud Zadehbagheri; Mohammad Javad Kiani; Tole Sutikno
International Journal of Electrical and Computer Engineering (IJECE) Vol 12, No 6: December 2022
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijece.v12i6.pp5821-5839

Abstract

In this research, we create a single-phase to ground synthetic fault by the simulation of a three-phase cable system and identify the location using mathematical techniques of Fourier and modal transforms. Current and voltage signals are measured and analyzed for fault location by the reflection of the waves between the measured point and the fault location. By simulating the network and line modeling using alternative transient programs (ATP) and MATLAB software, two single-phase to ground faults are generated at different points of the line at times of 0.3 and 0.305 s. First, the fault waveforms are displayed in the ATP software, and then this waveform is transmitted to MATLAB and presented along with its phasor view over time. In addition to the waveforms, the detection and fault location indicators are presented in different states of fault. Fault resistances of 1, 100, and 1,000 ohms are considered for fault creation and modeling with low arch strength. The results show that the proposed method has an average fault of less than 0.25% to determine the fault location, which is perfectly correct. It is varied due to changing the conditions of time, resistance, location, and type of error but does not exceed the above value.