Article Per Year (5 Year)
p-Index From 2019 - 2024
0.444
P-Index
This Author published in this journals
All Journal International Journal of Power Electronics and Drive Systems (IJPEDS)
Muhammad Nizam
Universitas Sebelas Maret
Control & Systems Engineering Electrical & Electronics Engineering

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

 1 
Constant current-fuzzy logic algorithm for lithium-ion battery charging Muhammad Nizam; Hari Maghfiroh; Azis Ubaidilah; Inayati Inayati; Feri Adriyanto
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 13, No 2: June 2022
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijpeds.v13.i2.pp926-937

Abstract

The lithium-ion (Li-ion) battery has a high demand because of its long cycle, reliability, high energy density, low toxic, low self-discharge rate, high power density, and high efficiency. However, lithium-ion batteries have sensitivity to over-charge, temperature, and charge discharge currents. The conventional battery charging system takes a very long time to charge which makes the battery temperature high. Therefore, a charger system that can maximize charging capacity, shorten charging time, and extend battery life is needed. In this study, a battery charging system was developed using the constant current–fuzzy (CC-fuzzy) control method. The aim is to get faster charging time and maintain battery life by limiting the battery charging temperature. The proposed charger system is dual mode which can be operated in both buck and boost mode. The experimental result shows that the proposed method is superior compared to the constant current constant voltage (CCCV) method in charging time. The CC-fuzzy method charging time is faster compared to the CCCV method by 25% and 12.5% in buck and boost modes, respectively. Whereas from the battery temperature, in buck mode, the proposed method has a lower temperature by 0.5 ⁰C and in the boost mode, each method has the same temperature.
Design of eddy current brake for electric motorcycle braking system Mufti Reza Aulia Putra; Muhammad Nizam; Dominicus Danardono Dwi Prija Tjahjana
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 12, No 1: March 2021
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijpeds.v12.i1.pp41-50

Abstract

Braking systems in motor vehicles generally use a braking system that utilizes friction. The braking performance will decrease caused by using friction rapidly. To overcome this, as an alternative, an electromagnetic braking system can be used by utilizing eddy currents, such as eddy current brakes (ECB). Eddy currents are generated when the rotor pass the magnetic field of the electromagnet. The research aim is to design an ECB system. The performance of the disk design will be determined in this study. The study is about the tendency of the ECB properties. The finite element (FEM) method is used by modeling ECB performance. The experimental results were used to validate the result. The test showed the results of braking using aluminum disk showed the best performance in 12.03 Nm. From these results, the combination of the disks is needed by an appropriate disk design.
Co-Authors Azis Ubaidilah Dominicus Danardono Dwi Prija Tjahjana Feri Adriyanto Hari Maghfiroh Inayati Inayati Mufti Reza Aulia Putra