Claim Missing Document
Check
Articles

Found 2 Documents
Search

Pengembangan Media Pembelajaran Berbasis Internet of Things Melalui Pendekatan STEM Investigative Science Learning Environment Untuk Meningkatkan Hasil Belajar Siswa Abdul Hamid; Muhammad Syukri; A Halim; Irwansyah Irwansyah
Jurnal Penelitian Pendidikan IPA Vol. 8 No. 4 (2022): October
Publisher : Postgraduate, University of Mataram

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.29303/jppipa.v8i4.1634

Abstract

This study aims to design and implement IoT-based media using the STEM-based ISLE model to improve student learning outcomes. This type of research uses Research and Development with the Dick & Carrey development model. The products produced are teaching aids based on the Internet of Things (IoT), student worksheet, and lesson plan. The IoT-based teaching aids were developed using Long Range Area (LoRa) SX1276, Raspberry Pi 3 Model B+, Arduino Uno, and DHT11 sensors, the data is displayed on the ThingSpeak web which has been integrated with the TTN (The Things Network) web for analysis by students. The results of the validation of teaching aids by media experts showed an average value of 4.20, material experts got an average value of 4.16, and observer teachers 4.83 which showed that the teaching aids were feasible to be applied. Validation was also carried out on student worksheets and lesson plans, the average value of student worksheets validation by media experts showed a value of 4.75, while by material experts 3.99 and by teacher observers 5, therefore student worksheets were feasible to be applied in the learning process, as well as with lesson plans with a validation value of 4.33. The results of the pre and post-test student learning outcomes showed an increase in the completeness of 70%. These results indicate that IoT-based media and products developed are feasible to be applied and can improve student learning outcomes in the learning process.
Optimization of the drilling campaign in reducing drilling cost in Block A Asset Ibnu Hafizh; Hasan Yudie Sastra; Irwansyah Irwansyah
Jurnal POLIMESIN Vol 20, No 1 (2022): February
Publisher : Politeknik Negeri Lhokseumawe

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.30811/jpl.v20i1.2546

Abstract

Drilling requires large costs with a very high risk of work, therefore good and careful planning is needed before it is carried out to obtain effective and efficient results by considering two aspects i.e. engineering and economics. Unstable conditions at the drilling site pose a high risk from the investor's point of view in terms of the total drilling costs that will be incurred in the area. The Platform drilling campaign implemented in Alur Siwah Phase 1 project is part of a project to increase gas recovery so that meets the gas raw materials demand in Aceh and the campaign is conducted using directional drilling technique. A descriptive method was used in the study and the data was gathered from the drilling activity reports during planning to post-drilling. Optimization using a drilling campaign during the drilling for the three wells in Alur Siwah Fase 1 resulted in a drilling cost savings of 26% and also saved execution time about 37 days from planning time