Article Per Year (5 Year)
p-Index From 2019 - 2024
0.23
P-Index
This Author published in this journals
All Journal JURNAL Al-AZHAR INDONESIA SERI SAINS DAN TEKNOLOGI
Daffa Amara Dzikri
Universitas Al Azhar Indonesia
Biochemistry, Genetics & Molecular Biology Computer Science & IT Electrical & Electronics Engineering Industrial & Manufacturing Engineering Public Health

Published : 1 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search

 1 
Analisis Potensi Kegagalan Jenis Defect Dominan Pada Transmission Case Dan Clutch Housing Menggunakan Metode FMEA-TOPSIS Daffa Amara Dzikri; Nunung Nurhasanah
JURNAL Al-AZHAR INDONESIA SERI SAINS DAN TEKNOLOGI Vol 8, No 2 (2023): Mei 2023
Publisher : Universitas Al Azhar Indonesia

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.36722/sst.v8i2.1408

Abstract

PT. Mitsubishi Krama Yudha Motors and Manufacturing Engine Factory, or PT. MKM 1 manufactures the TD-4V21 engine for canters and engine parts such as crankcase and timing gear, transmission, front axle, and differential case. This research was conducted at PT. MKM 1 on the Transmission Case and Clutch Housing production line aims to identify the dominant type of defect, analyze the potential causes of failure using the Failure Mode Effect and Analysis (FMEA) method, and determine the priority causes of failure to be repaired using the Technique for Others Reference by Similarity to the method. Ideal Solution (TOPSIS). In the production of TMTD & CLH, there are three dominant types of defects based on the application of the Pareto diagram, namely, the result of the NG thread process is 42%, the hole diameter plus-minus is 23%, and the outspent position is 13%. There are causes of failure that need to be addressed based on the analysis of the Ishikawa diagram and the application of the FMEA-TOPSIS method. In the results of the NG thread process, the causes of failure that need to be overcome are the wrong settings for tools, parts, or materials that are not smooth, there are iron ores. On the defect hole diameter plus-minus, try ex tool insert, loose bolt insert tool, and overspec tool dimension. While the outspent position there are causes of failure that need to be overcome, namely the length of the part over, improvements to the-axisscale, and panel brackets that are accidentally turned off.Keywords – Quality improvement, FMEA, TOPSIS, Diagram Ishikawa, Failure Mode Effect And Analysis, Technique For Others Reference By Similarity To Ideal Solution.
Co-Authors Nunung Nurhasanah