Claim Missing Document
Check
Articles

Found 2 Documents
Search

KAJIAN PERBAIKAN STRUKTUR PERKERASAN KAKU MENGGUNAKAN METODE PRESSURE GROUTING DENGAN MATERIAL POLYURETHANE DAN EPOXY (Studi Kasus : Ruas Jalan Patriot – Perintis Kemerdekaan Kota Pekalongan) Junianto, Arif; Ramadhan, Rifqi Maulana; Utari, Jantayu Padma; Kusdiyono, Kusdiyono; Pawiro, Dadiyono Amat; Junaidi, Junaidi
Wahana Teknik Sipil: Jurnal Pengembangan Teknik Sipil Vol 24, No 1 (2019): Wahana Teknik Sipil
Publisher : Politeknik Negeri Semarang

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.32497/wahanats.v23i1.1604

Abstract

Today the implementation of road infrastructure development using concrete pavement is experiencing rapid development because it can serve heavy and heavy traffic loads. But there are some problems that often arise in the use of concrete for pavement, causing damage (cracks). Repair of concrete cracks using pressure grouting method is one solution that can be used to improve the strength of concrete. This study discusses the comparison of the effectiveness of using polyurethane and epoxy materials in an effort to improve the rigid pavement structure. The research method used was to carry out repairs to the concrete structure on the Independence Patriotic-Road Section of Pekalongan City using polyurethane and epoxy materials. In this study each of the 5 existing normal (non-damaged) concrete samples, concrete repaired with polyurethane material and repaired concrete using epoxy material using core drill method, which will then be tested for compressive strength in the laboratory, as well as hammer test testing. to find out the strength of the existing concrete damage. The results showed that the average compressive strength of normal existing concrete (not damaged) amounted to 59.20 N/mm2, the average compressive strength of concrete that experienced cracks was 27.04 N/mm2, the average compressive strength value of repair concrete using polyurethane material is 31.92 N/mm2 (increasing by 15.17%) and the average compressive strength of concrete repair using epoxy material is 45.22 N/mm2 (increased by 56.53%).
Kajian Nilai Daya Dukung Tanah Lempung Merah Dengan Bahan Tambah Kapur Melalui Uji CBR Triwardaya, Triwardaya; Pawiro, Dadiyono Amat; Ukiman, Ukiman; Sutarno, Sutarno
Wahana Teknik Sipil: Jurnal Pengembangan Teknik Sipil Vol 20, No 2 (2015): WAHANA Teknik Sipil
Publisher : Politeknik Negeri Semarang

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.32497/wahanats.v20i2.147

Abstract

Soil materials that the grain size of the composition can comprise coarse material (gravel, sand) and fine materials (silt and clay). At the material / soil materials that include fine-grained soil that contains granules ø 0.075 mm over 50% will be dominated by clay content. This material will have a high value of plasticity and low power as well as developing a sizeable shrinkage. Lime that has binding properties (lime stone) when added to the material clay changes will provide both improved quality, bulk density, as well as lime-enabled so the added material on clay red around POLINES as filler material (filter) with different variations in the mix and treatment peneraman and soaking would boost its strength tested by the carrying capacity by means of CBR (California Bearing Ratio) test results in the laboratory value of CBR plans on condition brooded until 7 days: CBR its 2.4 kp + 20.8 with a level of correlation R = 0.9328 , And soaked conditions until 7 days: his CBR kp 4.4 - 0.8 with a degree of correlation R = 0.9874.