Article Per Year (5 Year)
p-Index From 2019 - 2024
0.444
P-Index
This Author published in this journals
All Journal JOURNAL OF ELECTRICAL AND SYSTEM CONTROL ENGINEERING Jurnal Mekanova : Mekanikal, Inovasi dan Teknologi
Gultom, Golfrid
Unknown Affiliation
Aerospace Engineering Automotive Engineering Electrical & Electronics Engineering Engineering Industrial & Manufacturing Engineering Mechanical Engineering

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

 1 
Sistem Start Direct Online Motor Induksi 3 Phase Berbasis Internet of Things Tarigan, Enda Rasilta; Rahmansyah, Abdul Azis; Gultom, Golfrid; Ginting, Manan
JOURNAL OF ELECTRICAL AND SYSTEM CONTROL ENGINEERING Vol. 8 No. 1 (2024): Journal of Electrical and System Control Engineering
Publisher : Universitas Medan Area

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.31289/jesce.v8i1.12624

Abstract

Digital technology continues to develop until now such as in Industry 4.0. In the industry, many still use conventional systems such as Induction Motor Starters using the Direct on Line (DOL) System. This study aims to build a system to be able to upgrade conventional systems to digital-based systems. The method used is testing by making a design and then comparing the data obtained to see the response time. From the results of the study, the system can work well. Both testing on conventional systems and online systems. In conventional systems, the system works faster with an average response time of less than 1 second, while with an online system, the response depends on the internet network used so that an average of 1.6 seconds is obtained. In addition, the results of testing using internet of things software show that the system is integrated between conventional systems and digital systems where when the induction motor is ON, a current reading of around 60A will be obtained on the IoT software display and when the motor is OFF, the current reading will drop to close to 0 Ampere.
PENGARUH GESEKAN MATERIAL RAW MIX PENYEBAB KEAUSAN TERHADAP VERTICAL MILL PADA TYRE VERTICAL MILL Darmadi, Herry; Gultom, Golfrid; Mustakim, Mustakim; Kurnia, Dian; Husainy, Husainy; Syabil, Irfan
Jurnal Mekanova : Mekanikal, Inovasi dan Teknologi Vol 9, No 1 (2023): April
Publisher : universitas teuku umar

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35308/jmkn.v9i1.7136

Abstract

Vertical roller mill is a combination of the system on millstone and rocker arm, in the process the millstone is driven by a motor so that it can rotate, the material enters through the middle of the millstone, with the centrifugal force the material above the millstone is ground by a roller which is pressured by a hydraulic cylinder. Tyre I experienced the largest wear rate with a total wear rate of 46,79 gr/hour, Tyre II experienced a wear rate of 38,58 gr/hour, Tyre III experienced a wear rate of 31,74 gr/hour, and the smallest Tyre IV experienced a wear rate of 24,90 gr /hour. And maintenance is done on the main components of the vertical mill so that the raw mix material can be processed properly.
Co-Authors Darmadi, Herry Ginting, Manan Husainy, Husainy Kurnia, Dian Mustakim Mustakim Rahmansyah, Abdul Azis Syabil, Irfan Tarigan, Enda Rasilta