Garuda - Garba Rujukan Digital

p-Index From 2019 - 2024

1.066

P-Index

This Author published in this journals

All Journal International Journal of Power Electronics and Drive Systems (IJPEDS) IAES International Journal of Artificial Intelligence (IJ-AI) Bulletin of Electrical Engineering and Informatics Indonesian Journal of Electrical Engineering and Computer Science

Dur Muhammad Soomro

Universiti Tun Hussein Onn Malaysia

Author-ID : 2402352

Computer Science & IT Control & Systems Engineering Electrical & Electronics Engineering Engineering

Published : 6 Documents Claim Missing Document

Claim Missing Document

Articles

Optimal design of a single-phase APF based on PQ theory Dur Muhammad Soomro; Sager K. Alswed; Mohd Noor Abdullah; Nur Hanis Mohammad Radzi; Mazhar Hussain Baloch
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 11, No 3: September 2020
Publisher : Institute of Advanced Engineering and Science

The instantaneous active and reactive power (PQ) theory is one of the most widely used control theory for shunt active power filter (SAPF), which can be implemented in single-phase and three-phase systems. However, the SAPF with PQ theory still had ability to improve to become more efficient. This paper presents the optimal design of a single-phase SAPF in terms of reducing the current harmonic distortion and power loss in voltage source inverter (VSI) controlled with the semiconductor switching devices IGBT, MOSFET and Hybrid (combination of IGBT and MOSFET). In order to reduce the switching frequency and power loss of VSI, instead of using single-band hysteresis current controller (HCC), double-band HCC (DHCC) and triple-band HCC (THCC) is used in the SAPF. The designed SAPF is tested with different non-linear loads to verify the results by using MATLAB Simulink.

Optimization of detection of single line to ground fault by controlling peterson coil through ANFIS Feryal Ibrahim Jabbar; Dur Muhammad Soomro; Adnan Hasan Tawafan; Mohd Noor bin Abdullah; Nur Hanis binti Mohammad Radzi; Mazhar Hussain Baloch
IAES International Journal of Artificial Intelligence (IJ-AI) Vol 9, No 3: September 2020
Publisher : Institute of Advanced Engineering and Science

The most common fault in the distribution network is the single line to ground fault (SLGF). With earthling in the distribution network, it causes electrical arc as well as a high voltage in the faulted phase compared to other two healthy phases. It increases the danger of separation and isolation in the power network. One of the classical technique to control the arc is through Peterson Coil (PC), which detects and turns off/reduces the electrical arc making the network safer, increasing its reliability and device's safety. To control the PC, some of the techniques used in this research area are PID, FL, NN etc. This paper presents Adaptive Neural-Fuzzy Inference System (ANFIS) technique to controlling the PC. It gives the best results by detecting the fault, reducing the electrical arc and minimizing the fault current to the rated current in a very short time. Moreover, this research focuses on suppressing fault current by looking at its higher and lower peaks. Also, it calculates the opposing inductance to compensate the capacitance caused. It will save thousands of tons of copper costs. This research was conducted using MATLAB. For the validity of the proposed technique results, PID control technique was used.

Design of parabolic solar dish tracking system using arduino Asif Ahmed Rahimoon; Mohd Noor Abdullah; Dur Muhammad Soomro; Murad Yahya Nassar; Z.A. Memon; P.H. Shaikh
Indonesian Journal of Electrical Engineering and Computer Science Vol 17, No 2: February 2020
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijeecs.v17.i2.pp914-921

This paper demonstrates the designing parameters of a solar parabolic dish prototype for rustic areas with great solar irradiance rate availability, where have no access of electricity services or low-income people survives to buy a stove (electric or gas). The solar parabolic dish prototype intends a solution against these types of remedies and pursues solar light to work. The parabolic dish has a polished surface, where the solar radiations fall and collected at a single concentrated focal point. At this point the collected form of energy is used to derive different thermal applications like as; cooking & heating with single and dual axis schemes. This paper discusses the important stages of dual axis prototype; implementation, solar location strategy, the analysis in terms of theory, structural design & material. The dual axis prototype is implemented through the help of Arduino chipboard that is easily in maintenance, along with that this prototype is configured with anti-lock H-bridge (L298) module to overcome the control circuit complexity and AVR modules. Two rotational motors of 12V are installed on 4*4ft designed aluminum frame with a dual-axis tracking system. The jerks among trackers are also reduced with this prototype which maintains the experimental declination angle about .To finish, this paper results that parabolic solar dish tracker obtains 3.43% improved power efficiency in comparison of photovoltaic panel tracker.

Adaptive position control of DC motor for brush-based photovoltaic cleaning system automation Ummi Sorfina; Syed Zahurul Islam; Kok Boon Ching; Dur Muhammad Soomro; Jabbar Al-Fatta Yahaya
Bulletin of Electrical Engineering and Informatics Vol 12, No 3: June 2023
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/eei.v12i3.4926

In this paper, we have developed an automatic brush-based PV cleaning system to control and synchronize the 3 motors together with a smooth periodic of cleaning while moving it horizontally over the PV surface. The mechanical design involved installing linear guides at the top and bottom of the rail to support the aluminium plate that holds the carrier motors and rotating brush. Two different movements of translational and rotational motion of the motors are managed by an algorithm programmed in Arduino Mega. In investigating the performance of motor parameters and dust removal rate, we conducted an experiment by spreading dry sand over the PV surface. Results showed that the torque of the cleaning brush motor increases with the increase in load. The obtained torque of the carrier motor was found to be 9.167 Nm ( stall torque, 9.8 Nm) with a full load of 18 brushes. The torque is inversely proportional to the speed but directly proportional to power. The required power to move the 2.93 kg of cleaning system was 19.20 W with 3.015 Nm of torque. The system achieved 86.8% of the dust removal rate from the four cycles of cleaning operations.

Optimize single line to ground fault detection in distribution grid power system using artificial bee colony Feryal Ibrahim Jabbar; Dur Muhammad Soomro; Mohd Noor bin Abdullah; Nur Hanis Mohammad Radzi; Mazhar Hussain Baloch; Asif Ahmed Rahmoon; Hassan Falah Fakhruldeen
Indonesian Journal of Electrical Engineering and Computer Science Vol 31, No 3: September 2023
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijeecs.v31.i3.pp1286-1294

The most common power system (PS) distribution network fault, single lineto-ground fault (SLGF), causes residual current (I res) to start an electrical arc and high voltage (HV) three times the rated voltage in other healthy phases. HV from capacitive currents (IC) damages cable insulation and PS appliances. Peterson The neutral point coil (PC) reduces (I res) and extinguishes the electric arc, but the fault current (I fault) remains below the protection devices' threshold. Operations and equipment are riskier. PC adaptive eliminates electrical arcs, making the network safer. This paper detects I faults online using Texas instrument validation in MATLAB and adaptive by artificial bee colony (ABC). This paper discusses Texas instrument fault current detection and MATLAB validation. It improves system reliability, device protection, and copper savings by thousands of tons. ABC intelligently optimizes many mathematical problems. ABC with network neural artificial intelligence (AI) improves algorithm performance (artificial bee colony network neural (ABCNN)). This new method may improve distribution network SLGF detection. This first work can work online in electrical power stations by building the (eZdsp F28335-RS232) into the program to send fault signals to the control when SLGF occurs without damaging devices, equipment, cables, or power outages.

Detection of single line to ground fault and self-extinguishing by using a variable and a fixedable inductance in distribution grid in power Feryal Ibrahim Jabbar; Dur Muhammad Soomro; Mohd Noor bin Abdullah; Nur Hanis binti Mohammad Radzi; Mazhar Hussain Baloch; Asif Ahmed Rahmoon; Hassan Falah Fakhruldeen
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 14, No 4: December 2023
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijpeds.v14.i4.pp2044-2051

This paper tackled the method for determining the number of Peterson coil which is can compensate with the capacitance because it is important in determining the state of parallel resonance, which in turn control the ground fault current and make the approximate value of the current equal to the current in the sound phases. In this way, we can protect the electrical devices and equipment from being damaged by residual current resulting from the arc due to ground fault, which increases the temperature of conductors which are to a breakdown of insulators and damaging them. Ground fault current equals three times the actual current, and its effect depends on two types of variables which are the first: the number of Peterson coils (which specify the inductance value and compensated) and second: the period time of extinguishing electric are in the ground fault. we obtain, by experimental in the lab where it using the servo motor to control the number of Peterson coils which in turn specify the variable and invariable inductance. We have obtained optimal results for the value of ground-fault current, detect the ground fault and treat it without effect of network load and without power cut off for consumer.

Co-Authors Adnan Hasan Tawafan Asif Ahmed Rahimoon Asif Ahmed Rahmoon Feryal Ibrahim Jabbar Feryal Ibrahim Jabbar Hassan Falah Fakhruldeen Hassan Falah Fakhruldeen Jabbar Al-Fatta Yahaya Kok Boon Ching Mazhar Hussain Baloch Mazhar Hussain Baloch Mazhar Hussain Baloch Mohd Noor Abdullah Mohd Noor bin Abdullah Murad Yahya Nassar Nur Hanis binti Mohammad Radzi Nur Hanis Mohammad Radzi P.H. Shaikh Sager K. Alswed Syed Zahurul Islam Ummi Sorfina Z.A. Memon

Title

Found 6 Documents
Search

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Title Search

Found 6 Documents Search

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Title

Found 6 Documents
Search