Claim Missing Document
Check
Articles

Found 2 Documents
Search
Journal : International Journal of Industrial Research and Applied Engineering

Investigation on Biomass Briquette as Energy Source from Waste Leaf Cerbera Manghas Willyanto Anggono; Fandi D. Suprianto; Sutrisno Sutrisno; Andreas W. Kasrun
International Journal of Industrial Research and Applied Engineering Vol 1, No 1 (2016)
Publisher : Institute of Research and Community Outreach - Petra Christian University

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (407.448 KB) | DOI: 10.9744/JIRAE.1.1.11-14

Abstract

Indonesia is a tropical country and has abundant varieties of plants but has not been utilized to the fullest. One of the plants that are often encountered in the community is Cerbera manghas. Cerbera manghas is known as one of the trees that have solid roots; thus, it is widely used for adding greenery both on the roadside and the residential areas of Surabaya. Although beneficial for shade and the reduction of air pollution in urban areas, waste from the leaves of this plant become a serious issue for the cleanliness of the city. Organic solid waste that comes from the falling leaves have the potential to be used as a solid fuel alternative in the form of briquettes when processed appropriately. This study aims to investigate the potential of Cerbera manghas leaves waste to be used as raw material of biomass briquettes with tapioca as a binder, to evaluate the property of the resulted briquettes using ultimate analysis, proximate analysis, and also to find the effect of the composition of tapioca to the heating value of the biomass briquettes. Heating values ​​of five mixtures with various tapioca compositions of 10%, 20%, 30%, 40%, and 50% were evaluated using an oxygen bomb calorimeter. The experimental results showed that the biomass briquettes made of Cerbera manghas leaves waste can be made using tapioca as a binder. The greater the percentage of the mass of tapioca in the briquettes, the lower heating value generated. Biomass briquettes made of Cerbera manghas leaves waste can be made into a source of sustainable energy with the optimal composition of 90% waste leaves and 10% tapioca.
Experimental Study of Combustion Fluctuation Reduction Using In-Cylinder Pressure Estimation in Gasoline Engine Mitsuhisa Ichiyanagi; Willyanto Anggono; Edyta Dzieminska; Takashi Suzuki
International Journal of Industrial Research and Applied Engineering Vol 3, No 2 (2018)
Publisher : Institute of Research and Community Outreach - Petra Christian University

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (452.913 KB) | DOI: 10.9744/jirae.3.2.51-60

Abstract

Gasoline engines needs to reduce its negative emission waste and raise its thermal efficiency. Previous studies have shown an improvement of engines by regulating the ignition timing and retaining the engine at certain air-to-fuel ratio. Additional development of the thermal efficiency is anticipated by reducing the oscillation of pressure due to combustion (referred to as combustion fluctuation) during each cycle. Reducing the combustion fluctuations promotes the generation of a stable combustion field and improves fuel consumption. Since the combustion fluctuations are significantly affected by the in-cylinder pressure at compression top dead center (referred to as TDC pressure), the present study proposes a method to estimate the TDC pressure in the next cycle. The estimation was conducted by measuring the in-cylinder pressure at exhaust valve opening in the given cycle. This study also developed the method to reduce the combustion fluctuations by using the TDC pressure estimation and controlling the ignition timing. In our experiments, it was found that the developed methods reduced the fluctuations of the indicated mean effective pressure (IMEP), the maximum in-cylinder pressure, and the TDC pressure by 62.1%, 51.2%, and 38.5%, respectively.