cover
Article Per Year (5 Year)
All
Home Page
OAI Link
Editorial Team
Contact
Reviewer
Google Scholar
Contact Name
Nurhadi Setiawan
Contact Email
jurnal.lemigas@esdm.go.id
Phone
+6221-7394422
Journal Mail Official
jurnal.lemigas@esdm.go.id
Editorial Address
Jl. Ciledug Raya Kav. 109, Cipulir, Kebayoran Lama, Jakarta Selatan 12230
Location
Kota adm. jakarta pusat,
Dki jakarta
INDONESIA
Scientific Contribution Oil and Gas
Published by Kementerian Energi dan Sumber Daya Mineral
ISSN : 20893361     EISSN : 25410520     DOI : https://doi.org/10.29017/SCOG.44.1.492
Core Subject : Science, Social, Engineering,
Chemical Engineering, Chemistry & Bioengineering Earth & Planetary Sciences Energy Environmental Science
research activities, technology engineering development and laboratory in the oil and gas field including regional geology/basin modeling, petroleum geology, sedimentology, stratigraphy, petroleum geoscience, drilling and completion technology, production engineering, well simulation, formation evaluation, petrophysics, reservoir characterization, oil and gas reserves, reservoir modeling, field development/management, EOR, geomachanics, unconventional hydrocarbon technology, field processing facilities, flow assurance, gas technology/processing/storage, petroleum processing/refining technology, petroleum products, fuel quality/specification/storage, biofuel technology, corrosion/scale problem/water treatment, environment/remediation, CCUS, health and safety/petroleum hazard, emerging technologies
Arjuna Subject : Energi (semua kategori) - Teknologi Bahan Bakar
Articles 5 Documents
 1 
Search results for , issue "Vol 41, No 3 (2018)" : 5 Documents clear
MOLECULAR DYNAMICS STUDY OF OLEIC ACID-BASED SURFACTANTS FOR ENHANCED OIL RECOVERY Suhendar, Aang; Hertadi, Rukman; Alli, Yani F
Scientific Contributions Oil and Gas Vol 41, No 3 (2018)
Publisher : PPPTMGB "LEMIGAS"

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (814.391 KB) | DOI: 10.29017/SCOG.41.3.331

Abstract

Surfactants have been intensively used for Enhanced Oil Recovery (EOR). Nevertheless, environmental issues cause some surfactants to become unfavored in EOR application. Biodegradable surfactants are the suitable choice to make the environment safer. However, screening surfactants that have a good performance for EOR are time-consuming and costly. Molecular Dynamics (MD) simulation is an alternative solution to reduce cost and time. In the present study, oleic acid-based surfactants that combined with the various length of polyethylene glycol were studied. The potential surfactants were screened by MD simulation to evaluate their ability to reduce the Interfacial Tension (IFT) between oil and water layers, which is the by GROMACS software with Gromos force field and SPC water model. Carboxyl-terminal of the oleic acid was substituted by a different length of polyethylene glycol. All MD simulations were prepared in octadecanewater mixture with temperature ranges of 303-363 K. Our simulations found that the increasing number of polyethylene glycol was not always followed by the decreasing of IFT value between octadecane and water layers. These results were validated with the experimental data and found the similar IFT profile. The simulation of oil emulsification showed that all surfactant samples have good performance and stability as exhibited by their emulsification rate and emulsion stability in different temperatures. The last test to get the best surfactant was the wetability test. The simulation gave the result that both PEG100-oleic and PEG400-oleic were able to change wetability of rocks from oil-wet to water-wet. Accordingly, PEG400-oleic is the best nonionic surfactant candidate due to its performance in each simulation test.
FOAMING CAN REDUCE LUBRICATION OF LUBRICANTS SO CAUSING WEAR Karina, Rona Malam; Hanifuddin, M; Wibowo, Setyo
Scientific Contributions Oil and Gas Vol 41, No 3 (2018)
Publisher : PPPTMGB "LEMIGAS"

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (525.492 KB) | DOI: 10.29017/SCOG.41.3.332

Abstract

Foaming on oil has a very undesirable effect which can cause an increase in oxidation by intensive mixture with air, damage to cavitation, and insufficient oil transportation in the lubrication circulation system which can cause poor lubrication. Adding the appropriate antifoam additives is one way to avoidfoaming. To determine the tendency of foaming formation which has an impact on the stability of the performance of lubricating oil, so that there is wear and tear in research in the laboratory by means of; 6 types of lubricating oil taken from the market are tested for viscosity, index viscosity, flash point, pour point and color. As well as to determine the effect of foam formation tested foaming tendency / stability and wear before and after antifoam added from 6 (six) types of lubricated oil obtained from the market. The result after adding antifoam additives, three types (GB, SH, and MH) of six types of lubricated oil were tested, the tendency of foaming and the wear results met the required limits, namely 0/50/0 ml for foaming tendency and maximum 0.5 mm for wear, while for 3 (three) oils, the results are not satisfying the required limits.
KINETICS OF BATCH MICROBIAL DEGRADATION OF PHENOL BY PSEUDOMONAS AERUGINOSA AND DEEP-SEA SEDIMENT BACTERIA: SCALE-UP Syafrizal, Syafrizal
Scientific Contributions Oil and Gas Vol 41, No 3 (2018)
Publisher : PPPTMGB "LEMIGAS"

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (884.943 KB) | DOI: 10.29017/SCOG.41.3.333

Abstract

Petroleum that is produced from several oil wells produces a fluid containing a mixture of petroleum, natural gas and produced water. The produced water usually contains hazardous chemicals such as hydrocarbons, sulfides, ammonia, phenols and other heavy metals. One of the high pollutants in the water produced is phenol. Through a biodegradation process, the contents of phenolic compounds in the produced water are expected to be reduced so that it meets the quality standards of waste water for oil and gas exploration and production activities. This research is development of the results of previous studies using a bioreactor with a larger scale, namely 3 L. The degradation process of phenolic compounds is carried out in optimal conditions, namely: pH 7, temperature 300C, and selected simple media: NP (5: 1) derived from urea and NPK + 0.1% yeast extract. The results of this study indicated that P. aeruginos and bacterial consortium may degrade phenolic compounds very well, which was 5.3 times faster than the previous studies. The biodegradation percentage was 98.40% in P. aeruginosa and 99.03% in bacterial consortium respectively. The monod kinetics model approach was successfully carried out and gave the value of parameters ?Max, Km, YS/X, and ?d respectively of 0.6305 hours-1, 0.0280 mg/L, 7 10-7 mg/L/ CFU/mL, and 0.00575 hours-1 in P. aeruginosa and 0.3272 hours-1, 0.0355 mg/L, 6.63 10-7 mg/L/CFU/ mL, and 0.00279 hours-1 in bacterial consortium. Based on the valuesof these parameters, P. aeruginosa has better affinity and growth.
PARABOLIC TROUGH COLLECTOR CONCENTRATING SOLAR POWER AS STEAM PRODUCER USING SOLAR IRRADIATION OF CEPU, BLORA, CENTRAL JAVA Burhan A.S, Andrian Aziz; Aziz, Dzul Fadhli; Hidayat, Muhammad Nur
Scientific Contributions Oil and Gas Vol 41, No 3 (2018)
Publisher : PPPTMGB "LEMIGAS"

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (950.429 KB) | DOI: 10.29017/SCOG.41.3.334

Abstract

Alternative energy sources has grown lately, especially for solar energy harnessed with Concentrating Solar Power (CSP) to produce steam that will be converted into a certain form of energy. The steam produced can also be used for petroleum industry to reduce the fuel usage in boilers. Daily solar irradiation of 5.18001 5.21909 kWh/m2 received by Cepu, Blora, Central Java, is deemed sufficient for CSP with parabolic trough collector (PTC) as steam producer. This paper describes the designing of the parabolic trough collector CSP, temperature increase gained from PTC, and peak temperature gained from 1 PTC. The initial experiment of PTC in cloudy, sunny, and cloudy-sunny-cloudy weather resulting in water temperature increase gained to be 172oC, 401.1oC, 285.9oC using Cepu District solar irradiation. Further experiments will be done to find out the relationship between temperature over time.
RAY-BINNING ANGLE STACK DOMAIN IN ENHANCING THE ROBUSTNESS OF CONVERTED-WAVE SEISMIC JOINT INVERSION Triyoso, Wahyu; Oktariena, Madaniya; Muhtar, Lucky Kriski
Scientific Contributions Oil and Gas Vol 41, No 3 (2018)
Publisher : PPPTMGB "LEMIGAS"

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (750.31 KB) | DOI: 10.29017/SCOG.41.3.330

Abstract

Converted-Wave Seismic has been proven as imaging alternative in aiding conventional seismic data when passing through gas cloud accumulation. However, asymmetrical approximation effect during Converted-Wave Seismic binning still remains in offset domain. PS-Reflection events in offset-domain are mapped using common-ray re-sorting technique by implementing the basic Snells Law of Mode Conversion. This produces an Angle Profile correspondent with the PP incident angle. Re-sorting the angle of converted-wave ray path to the PP-Wave propagation within the common imaging point, the Converted-Wave seismic would share similar angle range. Thus, improving the match in PP to PS event as data input preparation for Joint Inversion. Grouping the angle based on AVA Analysis, followed by stacking the Angle Profile into Common-Ray Partial Angle Stack, had proven to eliminate the fault shadow sagging zone and gas absorption illumination area in Converted-Wave Seismic. The final result of PP-Seismic imaging is more coherent with the Converted-Wave Seismic, in term of event alignment and amplitude character. This result lead to more robust PP-PS Joint Inversion, as the coherency between input data is an important key in simultaneous process. The comparison on derived Vp/Vs shows better improvements of subsurface imaging, especially in the near-surface gas masking area of conventional seismic.

Page 1 of 1 | Total Record : 5

 1 

Filter by Year

2018 2018


Reset
Filter By Issues
All Issue Vol 45, No 1 (2022): Issue In Progress Vol 44, No 3 (2021) Vol 44, No 2 (2021) Vol 44, No 1 (2021) Vol 43, No 3 (2020) Vol 43, No 2 (2020) Vol 43, No 1 (2020) Vol 42, No 3 (2019) Vol 42, No 2 (2019) Vol 42, No 1 (2019) Vol 41, No 3 (2018) Vol 41, No 2 (2018) Vol 41, No 1 (2018) Vol 40, No 3 (2017) Vol 40, No 2 (2017) Vol 40, No 1 (2017) Vol 39, No 3 (2016) Vol 39, No 3 (2016) Vol 39, No 2 (2016) Vol 39, No 1 (2016) Vol 38, No 3 (2015) Vol 38, No 2 (2015) Vol 38, No 1 (2015) Vol 37, No 3 (2014) Vol 37, No 2 (2014) Vol 37, No 1 (2014) Vol 36, No 3 (2013) Vol 36, No 2 (2013) Vol 36, No 1 (2013) Vol 35, No 3 (2012) Vol 35, No 2 (2012) Vol 35, No 1 (2012) Vol 34, No 3 (2011) Vol 34, No 2 (2011) Vol 34, No 1 (2011) Vol 33, No 3 (2010) Vol 33, No 2 (2010) Vol 33, No 1 (2010) Vol 32, No 3 (2009) Vol 32, No 2 (2009) Vol 32, No 1 (2009) Vol 31, No 3 (2008) Vol 31, No 2 (2008) Vol 31, No 1 (2008) Vol 30, No 3 (2007) Vol 30, No 2 (2007) Vol 30, No 1 (2007) Vol 29, No 3 (2006) Vol 29, No 2 (2006) Vol 29, No 1 (2006) Vol 28, No 3 (2005) Vol 28, No 2 (2005) Vol 28, No 1 (2005) Vol 27, No 3 (2004) Vol 27, No 2 (2004) Vol 27, No 1 (2004) Vol 26, No 2 (2003) Vol 26, No 1 (2003) Vol 25, No 3 (2002) Vol 25, No 2 (2002) Vol 25, No 1 (2002) Vol 23, No 3 (2000) Vol 23, No 2 (2000) Vol 23, No 1 (2000) Vol 18, No 1 (1995) Vol 17, No 1 (1994) Vol 16, No 1 (1993) Vol 15, No 1 (1992) Vol 14, No 2 (1991) Vol 14, No 1 (1991) Vol 13, No 1 (1990) Vol 12, No 1 (1989) Vol 11, No 1 (1988) Vol 10, No 3 (1987) Vol 10, No 2 (1987) Vol 10, No 1 (1987) Vol 9, No 1 (1986) More Issue