cover
Article Per Year (5 Year)
All
Home Page
OAI Link
Editorial Team
Contact
Reviewer
Google Scholar
Contact Name
Achmad Muchayan
Contact Email
achmad.muchayan@narotama.ac.id
Phone
+6285732060053
Journal Mail Official
ijeeit@narotama.ac.id
Editorial Address
NAROTAMA UNIVERSITY, Indonesia AR HAKIM 51 SURABAYA JAWA TIMUR www.narotama.ac.id
Location
Kota surabaya,
Jawa timur
INDONESIA
IJEEIT (International Journal of Electrical Engineering and Information Technology )
Published by Universitas Narotama Surabaya
ISSN : 26152088     EISSN : 26152096     DOI : https://doi.org/10.29138/ijeeit.v3i2
Core Subject : Science, Engineering,
Computer Science & IT Electrical & Electronics Engineering
is an open-access journal publishing original research from across all areas of the Electrical Engineering and Information Technology We offer our authors a highly respected home for their research. Partnering with our extensive network of expert peer reviewers, our editorial team provides rigorous, objective and constructive peer review, and will support you throughout the publication process. We led by the same ethical and editorial policy guidelines to ensure that all the research we publish is scientifically robust, original, and of the highest quality. We help your research reach more people and maximize its impact. As an open-access journal, we ensure that your work is immediately accessible and highly discoverable across a range of channels Focus and Scope IJEEIT publishes original research from all areas of the Electrical Engineering and Information Technology
Arjuna Subject : Ilmu Komputer (semua kategori) - Ilmu Komputer (Lain-Lain)
Articles 5 Documents
 1 
Search results for , issue "Vol 3 No 2 (2020): September 2020" : 5 Documents clear
Analysis of traffic accidents in the district Gresik (Case Study: Road Duduksampeyan Sta km 16 + 000 - Sta km 16 + 500) Debi Fariska; Sri Wiwoho Mudjanarko
IJEEIT : International Journal of Electrical Engineering and Information Technology Vol 3 No 2 (2020): September 2020
Publisher : NAROTAMA UNIVERSITY

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.29138/ijeeit.v3i2.1157

Abstract

Traffic accident is an accident that occurs unexpectedly and unintentionally involving a vehicle which resulted in casualties and material damage. The problem of traffic accidents on the road Duduksampeyan Sta km 16 + 000 - Sta km 16 + 500 is the most significant. The purpose of this study was conducted to determine the level of traffic accidents that occurred in 2013-2018. This study uses a method that refers to the calculation of the number of accidents. The observations in the field of road safety facilities are still inadequate, lighting is in only one side of the road as much as ± 10 pieces, and the absence of traffic signs (speed limits, accident-prone areas, etc.). The volume of daily traffic averages on these roads as much as 3833 veh / hour. The results of the analysis carried accident rate by 158 the highest annual accident / km occurred in 2018. Meanwhile, based on the fatality index, it was 47.76%, the highest in 2013.
Implementation of Docker and Continuous Integration / Continuous Delivery for Management Information System Development AKBAR DHANY
IJEEIT : International Journal of Electrical Engineering and Information Technology Vol 3 No 2 (2020): September 2020
Publisher : NAROTAMA UNIVERSITY

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.29138/ijeeit.v3i2.1208

Abstract

A series of Development and Operations (DevOps) in the process of making the Narotama University Management Information System have not been implemented properly by previous developers. There are improvements or additional features of the Management Information System that are in accordance with the functionality and the increasing development needs that will be used by the academic community, so that the Management Information System developer has a little difficulty in integrating documents and distributing applications with different packages to the Production Server. In this study, a new system design is proposed by applying the practice of Continuous Integration / Continuous Delivery as a document integration process and can simplify the application distribution process, as well as implementing the Docker Container Platform as an application container with different packages that can be run on production server together. The results of implementing the practice of Continuous Integration / Continuous Delivery and the implementation of the Docker Container Platform are able to help integrate documents between developers and be able to release fixes and add features packaged in different containers automatically and periodically without long delays. which only takes an average of 17.9 seconds in the process of sending the application to the Production Server.
PLC Based Load Sharing of Transformers Iqra Rana; Murtaza Ali; Faheem Shafeeque Channar; Munsif Ali; Mustafa Memon
IJEEIT : International Journal of Electrical Engineering and Information Technology Vol 3 No 2 (2020): September 2020
Publisher : NAROTAMA UNIVERSITY

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.29138/ijeeit.v3i2.1234

Abstract

The transformer is very expensive and bulky power system equipment. It runs and feed the load for 24 hours a day. Sometimes the load on the transformer unexpectedly rises above its rated capacity in that situation the load on the transformer increases and it will be overloaded and current will increase and cause overheating which in results damage the insulation of transformer. That insulation failure resulting in interruption of power supply. The common problems which transformer face is overloading voltage fluctuations and heating effect. It takes lot of time to fix the transformer so that a device need to be introduced a device which would help in automatically sharing of these over voltages. We will try to build an automated transformer sharing system in this project where the transformer current is confined to auxiliary transformer and automatically enters system. There are three transformers working as sources in this project, initially when the main switched ON the load that time load will be shared through the first transformer but when the load on first transformer suddenly increase above its reference value then immediately second transformer connected parallel with first transformer automatically through PLC by busing relay circuit.
Life cycle analysis of solar pv panels for their efiiciency, cost and environmental performance: a case study of hyderabad Muhammad Saad Khan; Shah Nawaz Soomro; Wahaj Asif; Arsal Mehmood; Dr. Nayyar Hussain Mirjat; Dr. Zubair Ahmed Memon; Suhail Ahmed
IJEEIT : International Journal of Electrical Engineering and Information Technology Vol 3 No 2 (2020): September 2020
Publisher : NAROTAMA UNIVERSITY

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.29138/ijeeit.v3i2.1235

Abstract

As the demand of energy increases, renewable technologies are dominating in the recent years. Solar energy is one of the leading technologies in all of the renewable energies, due to its simplicity. In Pakistan, solar PV stand-alone units are mostly used to meet the energy requirements. During production of solar PV panel, it emits out lot of waste heat and it is necessary to calculate these emissions. This study investigates the complete Life Cycle Analysis (LCA) of two different types of solar panels which are locally available in Hyderabad markets. Complete modeling of Monocrystalline and Polycrystalline PV panels has been done by using GaBi software. This study shows the complete waste heat emissions during each stage of PV panel production. Two different types (Monocrystalline and Polycrystalline) of solar panels are designed under the dimensions of 1 m2. It is calculated that Monocrystalline PV panels are more efficient than Polycrystalline PV panels and they generates more units of electricity under same temperature conditions during its complete life. To enhance the electrical efficiency of solar PV panel, cooling system must be provided across it. The comparative analysis shows that Polycrystalline PV panels requires less amount of electrical energy as compare to Monocrystalline PV panels resulting in the reduction of waste heat emission. At the end of life, this study highlights the significance of recycling of solar panels which consider the reuse of the raw material. In this study, the combination of mechanical, thermal, and chemical process of recycling is considered. Recycling rate of solar PV panel has been assumed to be 90%. Recycling of raw material reduces the waste heat emission during purification process of raw material. Thus, cost is reduced and beneficial for environmental aspects. Result shows that recycling of solar PV panel is more beneficial than landfill for environmental and economic aspects.
The Decision Support System For The Acceptance of Pencak Silat Athletes in Pra-PON and PUSLATDA Team Selection Using Technique For Other Preference By Similarity To Ideal Solution Method Mochammad Rizaldy; Achmad Muchayan; Made Kamisutara
IJEEIT : International Journal of Electrical Engineering and Information Technology Vol 3 No 2 (2020): September 2020
Publisher : NAROTAMA UNIVERSITY

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.29138/ijeeit.v3i2.1297

Abstract

Pencak Silat is one of the traditional martial arts that originated from Indonesia. The parent of Pencak Silat organization in Indonesia is INDONESIAN PENCAK SILAT ASSOCIATION (IPSI). Pencak Silat is one of the most reliable sports branches at the International-scale Olympics. Proven at the ASEAN GAMES 2018 Olympics and then the Pencak Silat Sports Branch is one of the sports branch of the most gold medal with a total of 14 medals. With the increasingly tight competition of Pencak Silat Sports, the trainer desperately needs athletes who fit certain criteria in order to be reliable in a tournament. In this study aims to assist the trainer in selecting athletes that correspond to the criteria. Therefore, a decision support system is required to assist the trainer in selecting qualified athletes. In this research, using the Technique for Other Preference by Similarity To Ideal Solution method is used to advise athletes who are eligible to be contested according to the calculation result. Result system of decision support system with Topsis method of this research has been tested by Pencak Silat Trainer and produce the results of the selection that is expected by the trainer. Keywords: Pencak Silat, Decision Support Systems, Technique For Other Preference by Similarity To Ideal Solution, Web

Page 1 of 1 | Total Record : 5

 1 

Filter by Year

2020 2020


Reset
Filter By Issues
All Issue Vol 6 No 2 (2023): September 2023 Vol 6 No 1 (2023): March 2023 Vol 5 No 2 (2022): September 2022 Vol 5 No 1 (2022): March 2022 Vol 4 No 2 (2021): September 2021 Vol 4 No 1 (2021): March 2021 Vol 3 No 2 (2020): September 2020 Vol 3 No 1 (2020): March 2020 Vol 2 No 2 (2019): September 2019 Vol 2 No 1 (2019): March 2019