cover
Article Per Year (5 Year)
All
Home Page
OAI Link
Editorial Team
Contact
Reviewer
Google Scholar
Contact Name
zainal abidin
Contact Email
zainalabidin@unisla.ac.id
Phone
+6281233532045
Journal Mail Official
jteunisla@unisla.ac.id
Editorial Address
Jalan Veteran No 53A Gedung Utama Kota : Lamongan Propinsi : Jawa Timur Negara : Indonesia
Location
Kab. lamongan,
Jawa timur
INDONESIA
JE-Unisla
Published by Universitas Islam Lamongan
ISSN : 25020986     EISSN : 26860635     DOI : https://doi.org/10.30736/je
Core Subject : Science, Engineering,
Computer Science & IT Control & Systems Engineering Electrical & Electronics Engineering Energy Engineering
Jurnal Penelitian Teknik Elektro/JE UNISLA (ISSN 2502-0986) adalah jurnal ilmiah yang bertujuan untuk mengkomunikasikan hasil dan riset teknologi dalam rangka untuk pengembangan teknologi di bidang teknik elektro. Sasaran pembaca adalah para ilmuwan, akademis, serta praktisi di bidang Teknik Elektro
Arjuna Subject : Teknik (semua kategori) - Teknik (Lain-Lain)
Articles 120 Documents
 1   2   3   4   5 
Simulasi Sistem Pentanahan Dengan Memodifikasi Konsentrasi Kadar Garam Muhammad Taqiyyudin Alawiy
Jurnal JE-UNISLA : Electronic Control, Telecomunication, Computer Information and Power System Vol 5, No 1 (2020)
Publisher : Universitas Islam Lamongan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.30736/je.v5i1.418

Abstract

Grounding system takes a very important role in the electricity and electronics device  protection system. The system is used for releasing current disturbance to the ground method. The smaller value of grounding system will give better system. In the certain ground, grounding resistance value is influenced by the depth and distance within the electrodes. The goal of this research is to find the characteristic of rod electrode grounding resistance and design computation method to calculate rod electrode resistance by changing its values and finally it can be used for the protection devices system reference. This research uses three point method to inject AC current into the electrode under test and a current probe and will give a potential between the earth electrode and the potential electrode, so the value of grounding resistance can be found. The result of the analysis indicates that the value of grounding resistance will be smaller when the deep of the planting, the amount of the rod electrode  buried and the distance of it are added. The decrease of grounding resistance value will be effective to 75 cm in deep and 300 cm in distance. While planting of rod electrode is deeper more than 75 cm and more 300 cm in distance not effective, because it can reduce the value of grounding resistance which does not have any mean. Therefore,  to get the small value of grounding resistance effectively, it is advised to add the amount of the electrode which is planted parallely. With the rod electrode installed before. However, it is important to notice when making the grounding system is the resistivity value of small and great of the ground  where the stability of grounding resistance is mounted. Finally, in planting grounding electrode it is important to have the geology data of the ground where the system applied.
Penggunaan SPSS Untuk Pembuktian Kebenaran Hukum Ohm Ulul Ilmi
Jurnal JE-UNISLA : Electronic Control, Telecomunication, Computer Information and Power System Vol 2, No 2 (2017)
Publisher : Universitas Islam Lamongan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.30736/je.v2i2.83

Abstract

Dalam penelitian ini pembuktian kebenaran hukum ohm akan diselesaikan dengan bantuan softwaere SPSS dengan menggunakan uji validasi korelasi pearson.Adapun data yang akan diuji kebenarannya bersumber dari hasil percobaan Tuan Ohm pada lampu 1. Untuk menyelesaikan persoalan pembuktian kebenaran hukum Ohm maka dapat digunakan bantuan SPSS ditempuh melalui beberapa tahapan sebagai berikut : (1) Menformulasikan persoalan pembuktian kebenaran hukum ohm ke dalam tabel SPSS, (2) Menuliskan koefisien dari variabel arus dan beda potensial listrik pada tabel SPSS sebagai representasi dari percobaan Tuan George Simon Ohm (3) Menuliskan simbol dari variabel arus dan beda potensial listrik pada tabel SPSS sebagai representasi dari percobaan Tuan George Simon Ohm, (5) Melakukan running program SPSS sebagai jawaban atas persoalan pembuktian kebenaran hukum ohm, (6) Nilai hasil perhitungan SPSS merupakan nilai korelasi arus dan beda potensial listrik sebagai solusi dari persoalan pembuktian kebenaran hukum ohm, (7) Jika diinginkan bisa menuangkan hasil penelitian dalam bentuk web.
Implementasi Sistem Kontrol Pakan Burung Puyuh Berbasis Mikrokontroler Dan Internet Of Things (Iot) Tijaniyah tijaniyah; Muhammad Firdaus; Muhammad Fikri Maula
Jurnal JE-UNISLA : Electronic Control, Telecomunication, Computer Information and Power System Vol 6, No 1 (2021)
Publisher : Universitas Islam Lamongan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.30736/je.v6i1.574

Abstract

The quail egg business is a type of business that is now popular with the community. Good quail care is also an important thing for the community to pay attention to, including feeding that should not be late, because if it is too late to feed, the quail can no longer produce eggs. Quail is capable of producing 10 to 20 eggs in one egg. The majority of people raise about 300 to 500 quails. Automatic feeding is one of the important things in this study. The time of feeding is morning, afternoon, evening and night. Researchers also use a microcontroller, nodemcu and the Internet of Things (IOT). The function of the IOT is as a remote control media on off feeding time and control the opening and closing of the door to the quail feed. 
Rancang Bangun Alat Pengusir Burung Pemakan Padi Berbasis Mikrokontroller Atmega328 Dengan Sel Surya Arief Budi Laksono; A Rifqi Zulfahmi Zahidi
Jurnal JE-UNISLA : Electronic Control, Telecomunication, Computer Information and Power System Vol 2, No 1 (2017): Jurnal Elektro
Publisher : Universitas Islam Lamongan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.30736/je.v2i1.32

Abstract

Penelitian ini bertujuan untuk merencanakan dengan mendesain alat pengusir burung pemakan padi berbasis mikrokontroller dengan sel surya sebagai . Dimana selama ini pengusiran burung oleh petani masih menggunakan cara-cara manual atau dengan bantuan kerja manusia. Program pada mikrokontroller Atmega328 menggunakan asembler atau C, sensor PIR digunakan untuk menangkap pergerakan burung. Untuk mengusik kehadiran burung menggunakan sirine yang mampu mengeluarkan suara dengan keras. Hasil yang diperoleh dari penelitian ini adalah desain Alat Pengusir Burung Pemakan Padi Berbasis Mikrokontroller Atmega 328 Dengan Sel Surya dengan sensor pir sebagai pendeteksi kehadiran burung.
Analisis Koordinasi Sistem Proteksi Trafo Distribusi 20 KV (Studi Kasus PT. PLN PERSERO Unit Lamongan) Nahdia Rupawanti BR
Jurnal JE-UNISLA : Electronic Control, Telecomunication, Computer Information and Power System Vol 4, No 1 (2019)
Publisher : Universitas Islam Lamongan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.30736/je.v4i1.307

Abstract

Electric power distribution systems that use air cables or ground cables often experience various disturbances. Interference that often occurs is symmetry or non-symmetric interference which can be a short relationship between one phase to the ground, between phases or the breakdown of one or more. To find out the magnitude of the interference current, an analysis of the transformer distribution system is needed to determine the disturbances that will occur.The transformer which is the main equipment in a GI must be considered in order to get the proper current circuit and security. Designing the right transformer setting is an effort to protect equipment, systems and consumer needs from disturbances that may occur in the distribution system. The calculation of the fault current and the magnitude of the nominal current of the transformer will be used as an important reference in determining the transformer settings in the distribution of voltage to consumers.From the results of these calculations it can be concluded that the performance time of feeder relays is slower than the time of relay in the event. The data in the field is still in the right condition (the difference is not too far), so that the overall OCR-GFR setting in the field is still in good condition.
Editorial JE-Unisla Vol 5 No 2 September 2020 Zainal Abidin
Jurnal JE-UNISLA : Electronic Control, Telecomunication, Computer Information and Power System Vol 5, No 2 (2020)
Publisher : Universitas Islam Lamongan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.30736/je.v5i2.509

Abstract

Editorial, Kata Pengantar dan Daftar Isi
Studi Analisis Audit Energi Untuk Konservasi Serta Efisiensi Listrik Gedung Unisla dengan Pendekatan Metode MCDM – Promethee Zainal Abidin; Aynin Churlillah D
Jurnal JE-UNISLA : Electronic Control, Telecomunication, Computer Information and Power System Vol 3, No 2 (2018)
Publisher : Universitas Islam Lamongan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.30736/je.v3i2.252

Abstract

In Islamic University of Lamongan (UNISLA), the use of electric energy is very important because there manyactivities in UNISLA it requires a lot of electrical energy and it can cause the waste of electrical energy.To overcome this, the need for a conservation and efficiency of electrical energy is needed. In this case, it is conducting an electrical energy audit. In this research, electrical energy auditing is done at Islamic University of Lamongan precisely in Building B and Building C. From the calculation of energy audit, it can be obtained the scoreof Energy Consumption Intensity (IKE) electricity at Building B is equal to 21,28 Kwh/m2/year and at Building C is 37.59 Kwh/m2/year. From these calculations, when compared to the standards set by the government, the IKE score is included in the category of quite efficient. But the researcher wants an effort to save electricity. The saving opportunities are changes in the SOP ofbuilding facilities, the adjustment of energy-efficient building design, the application of energy-saving technologies, and the development of optimal human resources. In this research,the saving effort can be done using MCDM-Promethee method. It is a method that can make an alternative rank according to the criteria obtained where every criteria is calculated using Analytical Network Processor. (ANP) method. These criteria include economy, work culture, occupant comfort, the influence of technology application, and the sense of owning of the building.From the ranking results can be obtained that the alternative saving efforts in Building B and Building C of Lamongan Islamic University is a change SOP (Standard Operating Procedure) building facilities.
Simulasi Kopling Magnetik Transfer Energi Nirkabel (Wireless Power Transfer) Affan Bachri; Zainal Abidin
Jurnal JE-UNISLA : Electronic Control, Telecomunication, Computer Information and Power System Vol 5, No 1 (2020)
Publisher : Universitas Islam Lamongan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.30736/je.v5i1.424

Abstract

One method  for energy transfer wireless is magnetic induction couplings. In general, copper is the most important element in producing magnetic flux in the form of coils or coils. Copper is used as an electrical transfer media because the material consists of many electrons that can move freely. Magnetic coupling simulation with Multisim 12.00 shows that the transmitter coil induces a receiver coil and energy transfer occurs.
Linear Equation System Study on Electrical Circuits Using Matlab Ulul Ilmi
Jurnal JE-UNISLA : Electronic Control, Telecomunication, Computer Information and Power System Vol 3, No 1 (2018)
Publisher : Universitas Islam Lamongan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.30736/je.v3i1.210

Abstract

In everyday life, especially in the electrical circuit, there are many usage of matrix. One use of a matrix is found in the system of linear equations. In the field of electrical circuits there are also problems involving systems of linear equations in matrix form. To solve the system of linear equations in matrix form, in addition to using elementary row operations, also used matlab.
Rancang Bangun Alat Penghitung Bibit Ikan Mujair Otomatis Berbasis Mikrokontroler Ulul Ilmi
Jurnal JE-UNISLA : Electronic Control, Telecomunication, Computer Information and Power System Vol 4, No 1 (2019)
Publisher : Universitas Islam Lamongan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.30736/je.v4i1.367

Abstract

Collection of fisheries and trade information it is very important to pay attention, reflecting on how to calculate fish seeds wich is manually what is done by taking fish seeds using doses (spoon) or using glass. In calculating farmers take fish seeds per five seeds per one measure. This method certainly requires a long time, especially if the number of fish seedlings to be purchased is large. In this final project, designed for automatic fish seed counting devices with Atmega328 microcontroller systems as a data processor, the photodiode sensor is the data sender and receiver, which is then displayed in LCD 16x2.So that we can get the addition of fish seeds automatically. The test result of the automatic fish binite counter will run if there is an object passing under the two LEDs that have a photodiode censor, then the data will be displayed on the LCD to show the number of fish passing.

Page 1 of 12 | Total Record : 120

 1   2   3   4   5 

Filter by Year

2017 2023


Reset
Filter By Issues
All Issue Vol 8 No 2 (2023): JE-UNISLA Vol 8 No 1 (2023) Vol 8, No 1 (2023) Vol 7, No 2 (2022): JE-UNISLA Vol 7, No 1 (2022) Vol 6, No 2 (2021) Vol 6, No 1 (2021) Vol 5, No 2 (2020) Vol 5, No 1 (2020) Vol 4, No 2 (2019) Vol 4, No 1 (2019) Vol 3, No 2 (2018) Vol 3, No 1 (2018) Vol 2, No 2 (2017) Vol 2, No 1 (2017): Jurnal Elektro More Issue