Article Per Year (5 Year)
p-Index From 2019 - 2024
0
P-Index
This Author published in this journals
All Journal Computer Engineering
Drs. Lingga Hermanto, MMSI
STMIK JAKARTA STI&K
Computer Science & IT

Published : 9 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 9 Documents
Search

 1 
Design Build VoIP Technology Implementation on Network Applications IP Phone via a Different Intranet Network. Shandi Noris; Drs. Lingga Hermanto, MMSI
Jurnal Sistem Komputer 2008
Publisher : STMIK Jakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Computer network technology and the internet today has become one of the important needs in life activities. Every day continues to grow, the development of a busy discussed and discussed today is the technology that lead to Next Generation Network (NGN) which will most likely be the technology platform on Internet Protocol (IP), one of the technology into use is a softswitch or known by the name Voice over Internet Protocol (VoIP). VoIP Technology able to communicate using voice infrastructure like the Internet using regular phone at no cost to regular phone. In addition, VoIP technology uses voice compression technology to provide efficiency and utilization bandwitdth, so that data communication is not disrupted.
TEST EQUIPMENT SERIAL COMMUNICATION INTERFACE RS-232 DB-9 TYPE CONNECTORS ON TESTING TECHNIQUES INSITU Derry Ekasaputra; Drs. Lingga Hermanto, MMSI
Jurnal Sistem Komputer 2005
Publisher : STMIK Jakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

At this writing will be made prober interface RS-232 in situ testing (testing onlocation) when the system interfaces operate without causing disturbances operatingsystem itself. For that tool is designed so that the information will be observed in thetest can be easily accessed via the display in the form of light and the values of thesignal information in the form of voltage level. To avoid the imposition of thiscommunication interface, the tool is equipped with the buffer. It is expected that thistool can provide rapid information, communication failures in the process of datathrough computer communication port.
CONTROL SYSTEM USING LIGHT MEDIA INFORMATION LINE TELEPHONE Yulikarnain Syam; Drs. Lingga Hermanto, MMSI
Jurnal Sistem Komputer 2005
Publisher : STMIK Jakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Human mobility is higher, so that almost all activities conducted outside the home.By utilizing the phone lines, home or office lighting systems can be controlled fromelsewhere during a phone facilities. This tool makes it easy for users to turn on orturn off the lights.By using the DTMF receiver, this tool will work if you've heard a dial tone with thetelephone receiver, where the receiver can generate a unique frequency, so thelighting can be controlled.Telephone frequencies generated will be converted into binary, which is thenconnected to the controller circuit of RS flip flop loads and relays.
THREE STATE LOGIC PROBE Adi Faizal; Drs. Lingga Hermanto, MMSI
Jurnal Sistem Komputer 2005
Publisher : STMIK Jakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Created a logic level detection circuit of a digital circuit. This circuit has the ability to3 (three) logic level digital signal is typically defined as follows: Level of highvoltage (High), low voltage level (Low) and the threshold voltage level (Theresehold).The ability of this series allows a digital circuit analysis to help level the better. Inthis series of tests in particular applied to the gates of the base.
TAP SWITCHES Asep Indra Gunawan; Drs. Lingga Hermanto, MMSI
Jurnal Sistem Komputer 2005
Publisher : STMIK Jakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

In this paper conducted a simple design tools such as Soft Switch system. This switch works with senttuhan, the first touch of this switch will be active (ON) and the second touch of this switch will be non-active (OFF). Operation switch, through the working circuit active components of the system dikaskada transistors, each transistor on the condition ON or OFF will enter the saturation region or the Cut-Off.The purpose of this scientific writing to provide an overview of design, including ease of operation and reliability. Understanding the operator ease of operation here requires only a relatively low operating energy is eventually able to move the actual, functioning as a relay connector and voltage breakers are very sensitive, touching on the device did not need to touch-hard but enough with the touch of a normal, ie operations switching at the touch of a relatively quite soft, it can activate the switch working. The expected result of timing differences between the touch operation by switching response in less than two seconds.
SISTEM DESIGN OF FAULT TOLERANCE PROTOTYPE DOOR CONTROLLER BASED SYSTEM PERSONAL COMPUTER Martian Logi Otama; Drs. Lingga Hermanto, MMSI
Jurnal Sistem Komputer 2006
Publisher : STMIK Jakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Fault tolerance describes a computer system designed to handle the event when the system experienced an error (fault) the work, which the backup or replacement procedures will replace the work experience component failures without interrupting the continuity of the systemIn this tool will be designed with fault tolerance system implemented on the controller door through techniques passcode Microsoft Access 2000 database.The system is designed so that a procedure will be run on a PC to detect failures in the activation of work and continued with a replacement system (redundant) that is executed through a program based on Microsoft Visual Basic 6.0. Execution of the bridge through 8255 PPI interface.
LINES TRACKERS ROBOT SENSOR INFRARED LINES THROUGH AT89C52 MICROCONTROLLER Ari Wibowo susanto,; Drs. Lingga Hermanto, MMSI
Jurnal Sistem Komputer 2006
Publisher : STMIK Jakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Autonomous Mobile Robot (AMR) is the robot that has the ability to move towards a certain point without human intervention. This research has built an AMR which has a mission to follow a line that has been determined by using infrared light as the sensor line. The purpose of this thesis is to design and implement a Line Tracer Robot using AT89C52 microcontroller and infrared sensors. AT89C52 microcontroller is used as the control center. Interruption of its facilities is very useful in responding to a line that is detected by sensors in real-time line.
PROBER UTP CABLE SYSTEM (Unshielded twisted PAIR) Muhammad Azhary; Drs. Lingga Hermanto, MMSi
Jurnal Sistem Komputer 2008
Publisher : STMIK Jakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

In making this writing, the author makes a simple tool with four pieces LED outputdisplay that lights up in sequence.The purpose of this paper is to analyze how the workings of the tool, as well as whatcomponents are used in the manufacture of this tool. In the research / writing, writer usemethod of literature study, namely mengumpukan materials related to this writing ofbooks and test equipment, ie, data collected from the experiment results by using the tooland then analyzed and explained.In this tool use Timer IC that functions as a clock in the display quickly slow theappearance of the display. And is also used IC 4017 (decade counter) that functions as achopper.
THREE STATE LOGIC PROBE Adi Faizal; Drs. Lingga Hermanto, MMSI
Jurnal Sistem Komputer 2005
Publisher : STMIK Jakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Created a logic level detection circuit of a digital circuit. This circuit has the ability to 3 (three) logic level digital signal is typically defined as follows: Level of high voltage (High), Level low voltage (Low) and the threshold voltage level (Thereshold). The ability of  this series allows a digital circuit analysis to help level the better. In this series of tests in particular applied to the gates of the base. 
Co-Authors Adi Faizal Ari Wibowo susanto, Asep Indra Gunawan Derry Ekasaputra Martian Logi Otama Muhammad Azhary Noris, Shandi Yulikarnain Syam