Claim Missing Document
Check
Articles

Found 3 Documents
Search
Journal : APTEK

ANALISA PRESSURE DROP PADA INSTALASI PIPA ALAT UJI RUGI-RUGI ALIRAN MENGUNAKAN CFD FLUENT 6.0 Sepfitrah -; Yose Rizal
Jurnal APTEK Vol. 5 No. 1 (2013): APLIKASI TEKNOLOGI
Publisher : Universitas Pasir Pengaraian

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (724.335 KB) | DOI: 10.30606/aptk.v5i1.72

Abstract

This study aims to determine the magnitude of the effect of component geometry pipeline and the pipe roughness on the performance of the pump and the pressure drop caused, then perform simulations to determine the fluid flow losses in pipe flow by using computational fluid dynamics program FLUENT 6.0 program package.Methods and objects used in this study is a series of piping by using various types of piping components. Installation tool is a Loss-Loss Test Equipment Flow Laboratory located in Pekanbaru STTP.From the results of tests performed in an actual magnitude of the resulting gas flow without doing the loading, when it is connected to the pipe line 1 maximum of 29 l / min at 2812 rpm rotation pump, and when connected to the pipe line 2 flow rate 35 l / min with the rotary pump 2849 rpm.
ANALISIS PERISTIWA KEGAGALAN PADA ”LEAF SPRING” TRUK COLT DIESEL PENGANGKUT PASIR Sepfitrah -; Yose Rizal
Jurnal APTEK Vol. 5 No. 2 (2013): APLIKASI TEKNOLOGI
Publisher : Universitas Pasir Pengaraian

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (852.863 KB) | DOI: 10.30606/aptk.v5i2.85

Abstract

Vehicle for pengakut goods such as trucks, have tended to point loading up backward toward the center of the body. The back of the truck so the suspension will experience a greater deflection than the suspension on the front. Truck rear suspension system uses leaf springs, which will undergo the toughest conditions in the compressive load over and over again, so the potential for failure due to material fatigue limit passing.In this research investigation into the leaf springs on trucks carrying sand in the form of a broken failure. A broken spring release of a series of truck suspension system to cut the rupture area and certain areas that want to be observed as a test specimen.
ANALISA KEGAGALAN FATIK PADA PLUNGER POMPA TORAK RECIPROCATING 5H3S Yose Rizal; Sepfitrah -
Jurnal APTEK Vol. 6 No. 1 (2014): APLIKASI TEKNOLOGI
Publisher : Universitas Pasir Pengaraian

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (1112.604 KB) | DOI: 10.30606/aptk.v6i1.93

Abstract

Pumps supply water used for steam generators in PT. CPI is a reciprocating type IR 5H3S used in the steam generators to be processed in order to supply water to steam. Compression pressure reciprocating pump is very large reaching 89.6 bars, is used to push the volume of liquid to be transferred through the exhaust system. The pressure generated by the movement of the pump plunger working pump suction and presses to compress the fluid. In fact plunger has fail until crack at the operational pressure.This study was conducted with the procedure properly. Through several stages with both the identification and investing the incident, which includes mechanical test hardness test, photo documentation fraktografi (mikrofraktografi and makrofraktografi) the material shaft patah. As approach to the truth has simulation to see the distribution of the forces acting on the piston rod (plunger rod).