cover
Article Per Year (5 Year)
All
Home Page
OAI Link
Editorial Team
Contact
Reviewer
Google Scholar
Contact Name
-
Contact Email
-
Phone
-
Journal Mail Official
jurtdm@batan.go.id
Editorial Address
Pusat Teknologi dan Keselamatan Reaktor Nukir (PTKRN) Badan Tenaga Nuklir Nasional (BATAN) Gedung 80 Kawasan Puspiptek Setu - Tangerang Selatan Banten - Indonesia (15310)
Location
Kota adm. jakarta selatan,
Dki jakarta
INDONESIA
Jurnal Teknologi Reaktor Nuklir Tri Dasa Mega
Published by Badan Tenaga Nuklir Nasional
ISSN : 1411240X     EISSN : 25279963     DOI : -
Core Subject : Science,
Energy Materials Science & Nanotechnology
Jurnal Teknologi Reaktor Nuklir "TRI DASA MEGA" adalah forum penulisan ilmiah tentang hasil kajian, penelitian dan pengembangan tentang reaktor nuklir pada umumnya, yang meliputi fisika reaktor, termohidrolika reaktor, teknologi reaktor, instrumentasi reaktor, operasi reaktor dan lain-lain yang menyangkut reaktor nukli. Frekuensi terbit tiga (3) kali setahun setiap bulan Februari, Juni dan Oktober.
Arjuna Subject : -
Articles 6 Documents
 1 
Search results for , issue "Vol 24, No 1 (2022): February (2022)" : 6 Documents clear
MEASURED AND CALCULATED INTEGRAL REACTIVITY OF CONTROL RODS IN RSG-GAS FIRST CORE Wahid Luthfi; Surian Pinem; Donny Hartanto; Lily Suparlina; Dwi Haryanto
JURNAL TEKNOLOGI REAKTOR NUKLIR TRI DASA MEGA Vol 24, No 1 (2022): February (2022)
Publisher : Pusat Teknologi Dan Keselamatan Reaktor Nuklir (PTKRN)

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.17146/tdm.2022.24.1.6593

Abstract

The control rod worth is one of the important parameters for the operation of a nuclear reactor. Proper measurement and calculation of the control rod worth are essential for the safe reactor operation under normal and transient conditions that are initiated by a postulated event such as a stuck rod, control rods ejection, etc. This paper presents calculation results of integral reactivity of the RSG-GAS research reactor first core and its comparison with the experimental data. Calculations were performed using the continuous energy transport code Serpent 2 with ENDF/B-VIII.0 nuclear data. Integral reactivity measurement was done by compensating method with control rod bank, regulating rod, and reactivity meter. Calculations are carried out for each method used in control rod measurement data with an aim to validate calculated results to experimental data. Compared with the measured experiment data, there are no significant differences in calculation results of integral reactivity. The maximum difference of the control rod's total reactivity is 1.26% compared to the measurement carried out by compensating method with regulating rod.
ANALYSIS OF COGENERATION ENERGY CONVERSION SYSTEM DESIGN IN IPWR REACTOR Ign. Djoko Irianto; Sriyono Sriyono; Sukmanto Dibyo; Djati Hoesen Salimy; Tukiran Surbakti; Rahayu Kusumastuti
JURNAL TEKNOLOGI REAKTOR NUKLIR TRI DASA MEGA Vol 24, No 1 (2022): February (2022)
Publisher : Pusat Teknologi Dan Keselamatan Reaktor Nuklir (PTKRN)

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.17146/tdm.2022.24.1.6414

Abstract

The acceleration of national development, especially in the industrial sector, requires an adequate national energy supply. There are various types of energy sources which include conventional energy sources as well as new and renewable energy sources including nuclear energy. The problem is how to utilize these energy sources into energy that is ready to be utilized. BATAN as a research and development institution in the nuclear field has taken the initiative to contribute to the development of technology for providing electricity and other thermal energy, particularly reactor technology as a power plant and a provider of thermal energy. This research aims to analyze the design of the IPWR type SMR reactor cogeneration energy conversion system. The IPWR reactor cogeneration energy conversion system which also functions as a reactor coolant is arranged in an indirect cycle configuration or Rankine cycle. Between the primary cooling system and the secondary cooling system is mediated by a heat exchanger which also functions as a steam generator. The analysis was carried out using ChemCAD computer software to study the temperature characteristics and performance parameters of the IPWR reactor cogeneration energy conversion system. The simulation results show that the temperature of saturated steam coming out of the steam generating unit is around 505.17 K. Saturated steam is obtained in the reactor power range between 40 MWth to 100 MWth. The results of the calculation of the energy utilization factor (EUF) show that the IPWR cogeneration configuration can increase the value of the energy utilization factor up to 91.20%.
DOSE DISTRIBUTION ANALYSIS OF PROTON THERAPY FOR MEDULLOBLASTOMA CANCER WITH PHITS 3.24 Moh. Miftakhul Dwi Fianto; Yohannes Sardjono; Andang Widi Harto; Isman Mulyadi Triatmoko; Gede Sutresna Wijaya; Yaser Kasesaz
JURNAL TEKNOLOGI REAKTOR NUKLIR TRI DASA MEGA Vol 24, No 1 (2022): February (2022)
Publisher : Pusat Teknologi Dan Keselamatan Reaktor Nuklir (PTKRN)

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.17146/tdm.2022.24.1.6581

Abstract

One of the developments in particle therapy is proton radiation therapy. Meanwhile, a limited number of available proton therapy facilities makes research related to proton therapy difficult. Therefore, there is a need for alternative proton therapy simulations using programs other than those in proton therapy facilities. This research was aimed to simulate medulloblastoma brain cancer which children often experience.The program used in this research was PHITS version 3.24. The human body was modeled with the revised ORNL-MIRD phantom for a 10-year-old child. The therapy scheme was a whole posterior fossa boost of 19.8 Gy. The proton passive scattering was simulated by passing a uniform proton beam through the aperture and compensator with energy variations. The proton pencil beam scanning was simulated with small cylindrical beams with a radius of 0.5 cm, which were adjusted to the planning target volume with layers variations.The total duration to give the prescription dose was 550 seconds with passive scattering and 605 seconds with pencil beam scanning. In passive scattering, the OAR(s) with the most significant percentage of absorbed dose were the skin, cranium, and muscle, i.e., 8.22 ± 0.15 %, 5.51 ± 0.05 % and 1.39 ± 0,04 % respectively to their maximum tolerated dose, while in the pencil beam scanning, the OAR(s) with the most significant percentage of absorbed dose were the skin, cranium, and muscle, i.e., 5.42 ± 0.08 %, 4.43 ± 0.05 % and 0.51 ± 0.05 % respectively to their maximum tolerated dose. Dose distribution in passive scattering was relatively better than in pencil beam scanning in terms of dose homogeneity using dose sampling analysis at some points within the planning target volume.
ANALYSIS OF FUEL TEMPERATURE REACTIVITY COEFFICIENT OF THE PWR USING WIMS CODE Santo Paulus Rajagukguk; Syaiful Bahkri; Tukiran Surbakti
JURNAL TEKNOLOGI REAKTOR NUKLIR TRI DASA MEGA Vol 24, No 1 (2022): February (2022)
Publisher : Pusat Teknologi Dan Keselamatan Reaktor Nuklir (PTKRN)

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.17146/tdm.2022.24.1.6329

Abstract

The Fuel Temperature Reactivity Coefficient (FTRC) is an important parameter in design, control, and safety, particularly in PWR reactor. It is then very important to validate any new library for an accurate prediction of this parameter. The objective of this work is to determine the value of the FTRC parameter using the new WIMDS library based on ENDF/BVIII.0 nuclear data files. For this purpose, it is used a set of light water moderated lattice experiments as the PWR-1175 MWe experiment critical reactors, the reactor using UO2 fuel pellet. The analysis is used with WIMSD-5B lattice code with original cross-section libraries and WIMSD-5B with ENDF/B-VIII.0 new cross-section libraries. The results showed that the fuel temperatures reactivity coefficients for the PWR reactor using original libraries is – 3.10 pcm/K with enrichment of 3.1% but for ENDF/B-VlII.0 libraries is – 3.00 pcm/K. Compared to the experimental data of the reactor core, the difference is in the range of 6.9 % for ENDF/B-VIII.0 libraries. It can be concluded that for the reactor, it is better to use ENDF/B-VIII.0 libraries because the original library is not accurate anymore.
Bagian Depan Vol.24 No. 1 (2022): February 2022 Editor in Chief
JURNAL TEKNOLOGI REAKTOR NUKLIR TRI DASA MEGA Vol 24, No 1 (2022): February (2022)
Publisher : Pusat Teknologi Dan Keselamatan Reaktor Nuklir (PTKRN)

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

This section consists of Cover Page, Editorial Board Page, Peer Reviewer Page, Table of Content Page and Preface Page
PREDICTION OF REMAINING USEFUL LIFE FOR COMPONENTS IN SSC OF RSG-GAS BASED ON RELIABILITY ANALYSIS Entin Hartini; Endiah Puji Hastuti; Geni Rina Sunaryo; Aep Saepudin; Sri Sudadiyo; Amir Hamzah; Mike Susmikanti
JURNAL TEKNOLOGI REAKTOR NUKLIR TRI DASA MEGA Vol 24, No 1 (2022): February (2022)
Publisher : Pusat Teknologi Dan Keselamatan Reaktor Nuklir (PTKRN)

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.17146/tdm.2022.24.1.6400

Abstract

In the maintenance system, efforts are needed to improve the effectiveness of the maintenance system and organization. For effective maintenance planning it is necessary to have a good understanding of the reliability and component availability of the system. For this reason, it is necessary to determine the remaining component life using Remaining Useful Life (RUL), so that maintenance tasks can be planned effectively. The purpose of this study is to determine the remaining life of the safety A component from SSC RSG-GAS based on reliability analysis. The method used in this paper is a statistical approach to estimating RUL. The Weibull hazard model is determined for modeling the hazard function so that it can be integrated in the reliability analysis. The model is verified using data from the safety A component from the SSC RSG-GAS. The results obtained from the analysis are useful for estimating the remaining useful lives of these components which can then be used to plan for effective maintenance and help control unplanned outages. The results obtained can be used for maintenance development and preventive repair planning.

Page 1 of 1 | Total Record : 6

 1 

Filter by Year

2022 2022


Reset
Filter By Issues
All Issue Vol 25, No 2 (2023): June 2023 Vol 25, No 1 (2023): February 2023 Vol 24, No 3 (2022): October 2022 Vol 24, No 2 (2022): June 2022 Vol 24, No 1 (2022): February (2022) Vol 23, No 3 (2021): October (2021) Vol 23, No 2 (2021): June 2021 Vol 23, No 1 (2021): FEBRUARY 2021 Vol 22, No 3 (2020): OCTOBER 2020 Vol 22, No 2 (2020): June 2020 Vol 22, No 1 (2020): February 2020 Vol 21, No 3 (2019): October 2019 Vol 21, No 2 (2019): JUNI 2019 Vol 21, No 1 (2019): February 2019 Vol 20, No 3 (2018): Oktober 2018 Vol 20, No 2 (2018): JUNI 2018 Vol 20, No 1 (2018): Februari 2018 Vol 19, No 3 (2017): Oktober 2017 Vol 19, No 2 (2017): Juni 2017 Vol 19, No 1 (2017): Februari 2017 Vol 18, No 3 (2016): Oktober 2016 Vol 18, No 2 (2016): Juni 2016 Vol 18, No 1 (2016): Februari 2016 Vol 17, No 3 (2015): Oktober 2015 Vol 17, No 2 (2015): Juni 2015 Vol 17, No 1 (2015): Pebruari 2015 Vol 16, No 3 (2014): Oktober 2014 Vol 16, No 2 (2014): Juni 2014 Vol 16, No 1 (2014): Pebruari 2014 Vol 15, No 3 (2013): Oktober 2013 Vol 15, No 2 (2013): Juni 2013 Vol 15, No 1 (2013): Pebruari 2013 Vol 14, No 3 (2012): Oktober 2012 Vol 14, No 2 (2012): Juni 2012 Vol 14, No 1 (2012): Pebruari 2012 Vol 13, No 3 (2011): Oktober 2011 Vol 13, No 2 (2011): Juni 2011 Vol 13, No 1 (2011): Pebruari 2011 Vol 12, No 3 (2010): Oktober 2010 Vol 12, No 2 (2010): Juni 2010 Vol 12, No 1 (2010): Pebruari 2010 More Issue