Article Per Year (5 Year)
p-Index From 2019 - 2024
2.076
P-Index
This Author published in this journals
All Journal Prosiding Seminar Nasional Sains Dan Teknologi Fakultas Teknik Jurnal Ilmiah Teknik Mesin Manutech : Jurnal Teknologi Manufaktur Jurnal Mesin Nusantara Dulang: Jurnal Pengabdian Kepada Masyarakat Prosiding Seminar Nasional Inovasi Teknologi Terapan Jurnal Inovasi Teknologi Terapan
Nanda Pranandita
Politeknik Manufaktur Negeri Bangka Belitung
Aerospace Engineering Agriculture, Biological Sciences & Forestry Automotive Engineering Chemical Engineering, Chemistry & Bioengineering Civil Engineering, Building, Construction & Architecture Computer Science & IT Control & Systems Engineering Electrical & Electronics Engineering Energy Engineering Industrial & Manufacturing Engineering Materials Science & Nanotechnology Mechanical Engineering Social Sciences Transportation Other

Published : 17 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search
Journal : Jurnal Mesin Nusantara

 1 
Rancang Bangun Alat Pembengkok Kawat Metal Jig Muhammad Yunus; Nanda Pranandita
Jurnal Mesin Nusantara Vol 4 No 1 (2021): Jurnal Mesin Nusantara
Publisher : Universitas Nusantara PGRI Kediri

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.29407/jmn.v4i1.16017

Abstract

An UMKM (micro, small and medium scale business) in the city of Pangkalpinang, Province of Kep. Bangka Belitung, with the trademark "kebajig Lure", produces metal jigs or artificial/fake bait made of metal. One of the problems in the process of making metal jigs at UMKM is bending the wire on the metal jig, because the bending process uses loop pliers which causes the wire to be made to be non-uniform (where 10 wires, below 50% of the wire deviates from tolerance) so that the stray wire must be repaired first before the metal jig molding process. In addition, the bending time of 1 piece of wire takes about 80 seconds. This study aims to accelerate the metal jig bending process and to obtain a uniform wire with a deviation of ± 0.2 mm. After conducting the survey and initial analysis, the making of tools for bending wire is the solution. In the process of making these tools, the VDI 2222 design method is used, starting from planning, conceptualizing, designing, and finally finishing. Then carried out the process of making tools and testing wire bending. The results of the experiments conducted showed that the uniformity level of the metal jig wire was around 70% and the time required in the 1-wire bending process was ± 10 seconds, with an efficiency of ± 70 seconds from the previous process. And in the metal jig molding process, the wire repaired before the molding process is only about 30%.
Co-Authors -, Arfendi -, Napitupulu Arriyani, Yang Fitri Ary Kiswanto Aswin, Fajar Deni Wahyudi Eko Yudo Hasdiansah, Hasdiansah Ilham Setyadi Juanda Juanda Ludy Firmansyah M Riva’i Masdani Masdani MUCHLIS KADAFI Muhamad Fikri Burli Muhamad Riva'i Muhammad Haritsah Amrullah Muhammad Yunus Muhammad Yunus Naca Kirana Naufal Dwi Yulian Pristiansyah Pristiansyah Putra Zarviansyah Rollastin, Boy Syahdan Hafiz Yuliyanto Yuliyanto Zaenal Zaenal